58KX-TGE240/242/243/244/245/260/262/263/264/270/272/273/274/275/TG454/TG465/TGEA20/TGA2012.2.4. CommandsSee the table below for frequently used commands.Command name Function Examplerdeeprom Read the data of EEPROM Type “rdeeprom 00 00 FF”, and the data from address“00 00” to “FF” is read out.readid Read ID (RFPI) Type “readid”, and the registered ID is read out.writeid Write ID (RFPI) Type “writeid 00 18 E0 0E 98”, and the ID “0018 E0 0E98” is written.hookoff Off-hook mode on Base Type “hookoff”.hookon On-hook mode on Base Type “hookon”.getchk (Base unit) Read checksum Type “getchk”.How to use of"getchk"in Handset1.rdeeprom Read EEPROM Type “RdEeprom 03 7D 04”, and the data from address"03 7D" to "03 80" is read out*This command gets 4 byte "WW", "XX", "YY", "ZZ".*Please NEVER forget these 4 byte data!2.sendchar epw Write EEPROM Type “sendchar epw 03 7D 04 FF FF FF FF”3.sendchar RST Reset baseset Type “sendchar RST”4.getchk Read checksum Type “getchk”.5.sendchar epw Write EEPROM Type “sendchar epw 03 7D 04 WW XX YY ZZ”*"WW", "XX", "YY", "ZZ" is 4 byte data that already readfrom same address.wreeprom Write the data of EEPROM Type “wreeprom 01 23 45”. “01 23” is address and “45”is data to be written.bursttx Burst TX mode Type “bursttx”testrx Burst RX mode Type “testrx”tph Keep TX power high Type"tph"tpl Keep TX power low Type"tpl"
