Panasonic KX-TGK210BX Operating Instructions Manual

Registering a handset to a baseunitThe supplied handset and base unit arepre-registered. If for some reason the handsetis not registered to the base unit (for example,is displayed even when the handset isnear the base unit), re-register the handset.1 Handset:M N#1302 MbN: Select a base unit number. a MOKNR This number is used by the handset asa reference only.3 Base unit:Press and hold M N for about 5 seconds.R If all registered handsets start ringing,press M N again to stop, then repeatthis step.4 Handset:MOKN a Wait until “Base PIN” isdisplayed. a Enter the base unit PIN(default: “0000”). a MOKNR If you forget your PIN, contact anauthorised service centre.Selecting a base unitWhen “Auto” is selected, the handsetautomatically uses any available base unit it isregistered to. When a specific base unit isselected, the handset makes and receivescalls using that base unit only. If the handset isout of range of that base unit, no calls can bemade.1 M N#1372 MbN: Select the desired base unit number,or “Auto”. a MOKNImportant:R When viewing the phonebook, caller list,etc., only the entries that are stored in thebase unit that the handset is currentlyconnected to are displayed.Deregistering a handsetA handset can cancel its own registration tothe base unit, or other handsets registered tothe same base unit. This allows the handset toend its wireless connection with the system.1 M N#131R All handsets registered to the base unitare displayed.2 MbN: Select the handset you want tocancel. a MOKN3 MbN: “Yes” a MOKN a M NCancelling a base unitA handset can cancel a base unit that it isregistered to. This allows the base unit to endits wireless connection with the system.1 M N#1392 MbN: Select the base unit you want tocancel. a MOKN3 MbN: “Yes” a MOKN a M NIncreasing the range of the baseunitYou can increase the signal range of the baseunit by using a DECT repeater. Please useonly the Panasonic DECT repeater noted onpage 3. Contact your Panasonic dealer fordetails.Important:R Before registering the repeater to this baseunit, you must turn the repeater mode on.R Do not use more than one repeater at atime.Setting the repeater mode1 M N#1382 MbN: Select the desired setting. a MOKNa M NRegistering the DECT repeater(KX-A405/KX-A406) to the base unitNote:R Please use a repeater that has not yet beenregistered to another unit. If the repeater isregistered to another unit, deregister it first,referring to the Installation Guide for theDECT repeater.30ProgrammingTGK2xxBXUE_OI(en)_0807_ver102.pdf 30 30/8/2017 11:22:06 AM