Useful InformationFor assistance, please visit http://www.panasonic.com/consumersupport 27SpecificationsSpeakerphone unitOperating environment:5 °C – 40 °C (41 °F – 104 °F)Dimensions:Approx. height 64 mm x width 279 mm xdepth 279 mm (217/32 " x 11" x 11")Mass (Weight):Approx. 970 g (2.14 lb.)Audio Out:Typical: Approx. −3 dBm (at 10 kΩ),0.03 mWMaximum: Approx. 0 dBm (at 10 kΩ),0.06 mWø3.5 mm mono mini jackPower consumption:Standby: Approx. 4.0 WMaximum: Approx. 7.0 WPower supply:AC adaptor (120 V AC, 60 Hz)Interface boxDimensions:Approx. height 32 mm x width 67 mm xdepth 76 mm (11 / 4" x 2 5/ 8 " x 3")Mass (Weight):Approx. 60 g (0.13 lb.)Note:L Design and specifications are subject tochange without notice.L The illustrations in these instructionsmay vary slightly from the actualproduct.This device complies with Part 15 of theFCC Rules. Operation is subject to thefollowing two conditions:(1) This device may not cause harmfulinterference, and (2) this device mustaccept any interference received,including interference that may causeundesired operation.CAUTION:Any changes or modifications notexpressly approved by the partyresponsible for compliance could voidthe user’s authority to operate thisdevice.NOTE:This equipment has been tested andfound to comply with the limits for aClass B digital device, pursuant to Part15 of the FCC Rules. These limits aredesigned to provide reasonableprotection against harmful interference ina residential installation. This equipmentgenerates, uses, and can radiate radiofrequency energy and, if not installed andused in accordance with the instructions,may cause harmful interference to radiocommunications. However, there is noguarantee that interference will not occurin a particular installation. If thisequipment does cause harmfulinterference to radio or televisionreception, which can be determined byturning the equipment off and on, theuser is encouraged to try to correct theinterference by one or more of thefollowing measures:− Reorient or relocate the receivingantenna.− Increase the separation between theequipment and receiver.− Connect the equipment into an outlet ona circuit different from that to which thereceiver is connected.− Consult the dealer or an experiencedradio/TV technician for help.