Flash Hook EventDescription Specifies the type of signal sent when sending a flash hook event.Value Range • Signal• flashhookDefault Value SignalConfiguration File Reference FLASHHOOK_CONTENT_TYPE (Page 236)Direct Call PickupDescription Specifies the feature number assigned to a BLF for performing callpickup.Value Range Max. 4 charactersDefault Value Not stored.Configuration File Reference NUM_PLAN_PICKUP_DIRECT (Page 202)4.6.1.2 Call Rejection Phone Numbers1–30Description Specifies the phone numbers to reject incoming calls from. A maximumof 30 phone numbers can be specified.Note• You can also configure this setting through the phone userinterface. If these settings are changed through the phone userinterface while being changed through the Web user interface,the settings made through the phone user interface will beoverwritten by the settings made through the Web userinterface.Value Range Max. 32 charactersNote• Even if you specify nonconsecutive fields (e.g., fields 1, 5, and30), they will be rearranged into consecutive fields after yousave the settings (i.e., 1, 2, and 3).• If the phone number contains characters other than 0–9, *, #,and +, the number may not be rejected correctly.Default Value Not stored.4.6.2 Call Control [Line 1]–[Line x]This screen allows you to configure various call features that are specific to each line. The number of linesavailable varies depending on the phone being used, as follows:• KX-UT113/KX-UT123: 1–2Document Version 2012-02 Administrator Guide 1234.6.2 Call Control [Line 1]–[Line x]
