2021. 8 panasonic.net/id/pidsx/globalME-LPRF-SM-11Please read these instructions carefully before using thisproduct, and save this manual for future use.Laser MarkerSetup /Maintenance GuideLP-RF series

Panasonic LP-RF Series Setup & Maintenance Manual

Preface

Cautions in Handling

How to Read this Document

Preparation of Command Control

Operation by External Devices

Operation procedure with external control

Settings before external control

Remote mode settings

Serial Communication Interfaces

RS-232C

Communication settings (LP-400/V compatible mode)

Ethernet

Communication settings

Connecting to external control devices and its setting sample

Checking the communication commands

Communication Control Basics

Communication Data Types

Communication Sequence

Communication Data Format

Request data

Response data

Character input method

Character data input method

Command Reception Condition

Commands acceptable only with the shutter closed

Communication Check

Control Sample

Data Format for Each Command

Command List

Command Description Details

Operation Control Commands

Laser pumping: LSR

Shutter open/close: SHT

Marking trigger: MRK

Trigger delay: DLY

Guide laser: GID

Status checking: STS

Marking end verification: MST

File Setting Commands

File selection by name: FNN

Overwrite file: FOR

File name: FNM

Character Setting Commands

Character entry (by ASCII and Shift-JIS code): STR

Character entry per trigger: SIN

Character object settings: STC

Character object settings (shortened): SPC

Functional Character Commands

Counter reset: CTR

Expiry date/time settings: LMT

Lot settings: LTC

Lot period/character: LTS

Registered character settings: RKC

Registered character strings: RKS

Bar Code/2D Code Settings Commands

Bar code/2D code characters (by ASCII and Shift-JIS code): BRS

Bar code/2D code object settings: BRF

Human readable text settings: BRV

Module filling of 2D codes: BRP

Command for graphic data settings

Graphic object settings (VEC format file) : CDC

Point Radiation Commands

Point radiation correction: PRF

Layout/Position Adjustment Commands

External offset settings: OFC

External offset values: OFS

Step & repeat settings: SRC

Step & repeat fine-adjustment: SRA

On-the-fly Marking Commands

Encoder resolution: ENC

Line speed: LSP

Workpiece spacing: INT

Laser Setting Commands

Scan speed: SSP

Laser frequency / pulse cycle: MPL

Laser fine tune: WTC

Line width / filling line spacing: WDC

Maintenance Commands

System Settings Command

Command mode: RSM

Troubleshooting

Error Indication

Warning: E600 - E799

Character Code Table

ASCII Code

Shift JIS Code

Index

LP-RF Series

LP-RF200P