– 10 –Control reference guide (continued)Rear PanelVIDEOVIDEOS-VIDEOS-VIDEO12YCH1(A)DV IN RS-232C USB~ AC INPAUSEREMOTECH2(B) CH1 CH2PB PRVIDEO INVIDEO OUTAUDIO IN AUDIO OUT AUDIOMONDV IN (4-pin)DV input. Connect a 4-pin IEEE1394 cable. You candigitally input video and audio.PAUSE REMOTE (Stereo mini jack)External control jack for recording start and pausecontrol. This jack also outputs a recording status signal.Audio CH1 (A)/CH2 (B) input connector (PHONO)Input for analog audio. If you have connected amicrophone, use the Audio CH assignment with Micsetting in the SETUP menus to assign recordingchannels.Security LockThis can be used to connect a commercially-availabletheft-prevention cable (manufactured by Kensington).This security lock is compatible with the MicrosaverSecurity System from Kensington.Audio CH1/CH2 output connector (PHONO)Analog audio output.Audio Monitor output connector (PHONO)Analog audio output. Use the Monitor setting item in theFUNCTION menus to assign the channel to be output.RS-232C Remote connector (D-sub 9P)RS-232C terminal. Connect a computer or other controldevice to enable external control.USB Remote connector (Type-B connector)USB terminal. Connect a computer or other controldevice to enable external control.Power socketConnect power cord (supplied).When connecting this unit to any other component,make absolutely sure that it is properly grounded byconnecting this terminal.When connecting, use the socket and be sure to usewire with a cross-sectional area of at least 1.0 mm2.VIDEO IN (BNC)Composite signal input.VIDEO OUT 1/2 (BNC)Composite signal output.Y, PB, PR (Component Video output) (BNC)Component signal (Y, PB , P R ) output.S-VIDEO IN (4P)S-Video (Y/C) input.S-VIDEO OUT (4P)S-Video (Y/C) output.Equipotential terminalCross-sectional area :More than 1.0 mm 2 SocketDownloaded From Disc-Player.com Panasonic Manuals