Panasonic LUMIX DMC-TZ60EB Service Manual

4610.3.1.3. Execute Adjustment1. Perform step "10.3.1.1." to "10.3.1.2.", to reset the OISflag status "F" (Set) to "0" (Reset).2. Press DISPLAY button after Flag reset.OIS Adjustment screen is displayed on the LCD panel.(Refer to Fig.3-4)3. Press the shutter button. The adjustment will startautomatically.4. When the adjustment is completed successfully,adjustment report menu appears with Green OK on theLCD monitor. (Refer to Fig.3-5) Fig. 3-4Fig. 3-510.3.1.4. Attention point during Adjustment1. Step "10.3.1.3." procedure shows OIS adjustment as anexample. To perform the adjustment, refer to the "10.3.2.Adjustment Specifications" table which shows key pointfor each adjustment.2. Do not move the light box, the camera or the chart whileadjusting. If one of these is moved accidentally, start theadjustment again.3. Do not press any buttons/keys until the default menu(Fig.3-6) is displayed on the LCD monitor. Otherwise,adjustment data may not be stored properly.4. If the adjustment is interrupted accidentally, the alignmentdata may not be properly saved in the Flash-rom.Fig. 3-610.3.1.5. Finalizing the Adjustment1. Several adjustment flags can be reset ("F" into "0") at the same time. In this case, when the adjustment has been completed,the screen will change showing the adjustment for the next item until all reset items are completed.Also, when the shutter button is pressed, the screen jump to the next adjustment item.2. To cancel the adjustment mode while in the process of performing the adjustment, follow this procedures.(1) Press "Right of cross key" button.Note:*.If adjustment is cancelled with above procedure, adjustment is not completed. Make sure to adjust it later.