Panasonic Lumix DMC-FS20 Operating Instructions Manual

Also see for DMC FS20P - Lumix Digital Camera: Service manual Instrucciones de funcionamiento

Contents

3VQT1M59Before UseTHE FOLLOWING APPLIES ONLY IN CANADA.THE FOLLOWING APPLIES ONLY IN THE U.S.A.THE SOCKET OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT ANDSHALL BE EASILY ACCESSIBLE.CAUTIONDanger of explosion if battery is incorrectly replaced. Replace only with the same orequivalent type recommended by the manufacturer. Dispose of used batteriesaccording to the manufacturer’s instructions.WarningRisk of fire, explosion and burns. Do not disassemble, heat above 60 xC (140 oF) orincinerate.Product Identification Marking is located on the bottom of units.This Class B digital apparatus complies with Canadian ICES-003.FCC Note:This equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses, and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, theuser is encouraged to try to correct the interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.• Consult the dealer or an experienced radio/TV technician for help.FCC Caution: To assure continued compliance, follow the attached installationinstructions and use only shielded interface cables with ferrite core whenconnecting to computer or peripheral devices.Any changes or modifications not expressly approved by the party responsible forcompliance could void the user’s authority to operate this equipment.