Connecting to other equipment- 101 -Disconnecting the USB connection cable safely• Proceed with the hardware removal using “Safely Remove Hardware” on the task trayof the PC. If the icon is not displayed, check that [ACCESS] is not displayed on the LCDmonitor of the digital camera before removing the hardware.Note• We recommend placing a soft cloth under this unit to prevent scratching.• Turn the camera off before connecting or disconnecting the AC adaptor (DMW-AC6PPfor DMC-LS85PU/DMC-LS86PU, DMW-AC6E for DMC-LS85EG/DMC-LS85EP: optional:P110).• Before inserting or removing a card, turn the camera off and disconnect the USBconnection cable. Otherwise, data may be destroyed.• With the Mac OS X v10.2 or an earlier operating system, set the Write-Protect switch ofthe SDHC memory card to the [LOCK] position when importing pictures from an SDHCmemory card.Viewing the contents of the built-in memory or card using the PC (foldercomposition)1 Folder number2 File number3 JPG : PicturesMOV : Motion picturesMISC: PRINT SETFavouriteDCIMMISC100_PANA101_PANA999_PANAP1000001.JPGP1000002.JPGP1000999.JPG100_PANA12 3Built-inmemoryCard••A new folder is created when pictures are taken in the following situations.• When a card containing a folder with the same folder number has been inserted (Suchas when pictures were taken using another make of camera)• When there is a picture with file number 999 inside the folderConnection in the PTP mode (Windows® XP, Windows Vista® and Mac OS X only)Select [PictBridge (PTP)] when connecting USB cable.Data can now be read only from the card into the PC.• When there are 1000 or more pictures on a card, the pictures may not be imported inthe PTP mode.Using a PC with an SD Memory Card slot or a card readerAttach the SD card according to the operating instructions of computer or card reader andperform steps 3-5 on page 100.• You cannot use SDHC cards if the computer or card reader does not support SDHCcards.