Panasonic Mail Monitor Station Installation Manual

Also see for VL-MV10: Operating instructions

Contents

Main monitor installationpositionAbout the installation position of the mainmonitor and mounting bracketR Place the main monitor in a location that youreyes are the same height as the centre of thedisplay.R For the following reasons, leave at least 20 cm(A) of space above, below, and to the left andright sides of the main monitor:– To prevent malfunction and sound cutting out– To ensure to make sure the reset button (B)can be used (the reset button is on thebottom of the main monitor)11112R After deciding where to install the main monitor,attach the mounting bracket in the locationshown below.DECC Main monitor installation positionD 65 mmE 50.7 mmInstalling the main monitor1 Attach the mounting bracket (A) to the wallsecurely.R Install the mounting bracket on a vertical flatwall (B).A BCDE FGHC Screws (accessory)D Hole in wall E 60 mm F 83.5 mmG 7 mm H 50 mm2 Connect the wires.R Connect the wires correctly according to"Wiring schematic diagram".R How to make wiring connectionsWhile pressing on the button (A) with apointed object such as a screwdriver, insertthe wire into the terminal connector (B).(To disconnect a wire, while pressing on thebutton (A), pull out the wire.)BCDAC Bare wire at tip 9 mmD Wiring from the connected device(example: lobby station, distributor,or other device)6

/ 8

Related manuals for Panasonic VL-MV10