Panasonic NV-DS88EN Operating Instructions Manual

Contents

6212:30:4515.10.200112:30:4515.10.200112:30:4515.10.200112:30:4515.10.20012 32LCD/EVF SETPRESS MENU TO RETURNLCD BRIGHTNESS[-]||||----[+]LCD COLOUR LEVEL[-]||||----[+]EVF BRIGHTNESS[-]||||----[+]180x 90x121112OPENPUSH1, 23 1CAMERAVCRCARD P.BMODEONOFFTurning on the Movie Camera and SelectingModesTurn on the power first and then select modes.ª How to Turn on the Power1 Set the [OFF/ON/MODE] Switch to [ON] while pressing thecentre button 1.≥The [CAMERA] Lamp lights up.ª How to Switch Modes2 Slide the [OFF/ON/MODE] Switch.≥With each slide, the Mode changes.≥The appropriate Mode Lamp lights up.ª How to Turn off the Power3 Set the [OFF/ON/MODE] Switch to [OFF] while pressing thecentre button 1.~~~~~~~~~~~~~~~~~~~~~~~~Using the Viewfinder/LCD Monitorª Using the ViewfinderBefore using the Viewfinder, adjust the field of view so that the displays insidethe Viewfinder become clear and easy to read.1 Tilt the Viewfinder upward.≥The Viewfinder can also be pulled out for use.≥Do not pull on the Eyecup to extend the Viewfinder.2 Adjust by sliding the Eyepiece Corrector Knob 1.ª Using the LCD MonitorWith the LCD Monitor open, you can also record the picture while watching it.1111 Press the [PUSH OPEN] Button and, at the same time, bringthe LCD Monitor out about 90o in the direction of the arrow.≥The Viewfinder goes off.2222 Adjust the LCD Monitor angle according to the desiredrecording angle.≥The LCD Monitor can rotate a maximum of 180o 2 from the verticalposition to the upward direction and a maximum of 90o 3 to thedownward direction. Forcefully rotating the LCD Monitor beyond theseranges will damage the Movie Camera.Closing the LCD MonitorPush the LCD Monitor until the [PUSH OPEN] Button is securely locked.ª Adjusting Brightness and Colour LevelWhen [LCD/EVF SET] on the [DISPLAY SETUP] Sub-Menu is set to [YES],the following items are displayed. (l 63)LCD Brightness [LCD BRIGHTNESS]It adjusts the brightness of the image on the LCD screen.LCD Colour Level [LCD COLOUR LEVEL]It adjusts the colour saturation of the image on the LCD screen.Brightness of the Viewfinder [EVF BRIGHTNESS]It adjusts the brightness of the image in the Viewfinder.To AdjustPress the [PUSH] Dial and select the item to be adjusted, and then turn the[PUSH] Dial to raise or lower the number of vertical bars in the Bar Indication.≥A larger number of vertical bars indicates stronger brightness or coloursaturation.Increasing the Brightness of the Entire LCD MonitorSet the [LCD MODE] on the [DISPLAY SETUP] Sub-Menu to [BRIGHT].≥These adjustments do not affect the recorded images.≥For other notes concerning this item, see page 98.