No.DS-PAN1311/21USBREV.1.1PAGE3 of 11Quick Start GuideEvaluation Board (EVB) PAN1311/21 USB DATE15.09.2011PANASONIC ELECTRONIC DEVICES EUROPEGmbHDESIGNEDErstelltIW2. INTRODUCTIONThis document should provide the minimum knowledge needed to establish a simpleconnection between two PAN1321ETU USB Evaluation Boards (EVB) using InfineoneBMU_SPP_Toolbox software. For this limited information is granted. To learn about allaspects of the software please refer to the related documents listed below.2.1 RELATED DOCUMENTSFor further information on Infineon eBMU_SPP_Toolbox software and it’s implemented ATcommand set please refer to:• PAN13x1_ReleaseNote_SPP_AT_SW08_V1.8_RN_Rev1.0_DRAFT• PAN13x1_ReleaseNote_SPP_AT_SW21_V2.1_RN_Rev1.0_DRAFT -iPhone version• PAN13x1_SPP_AT_UserManual_SoftwareDescription_Rev5.0 DRAFT• PAN1321_AN_DesignGuide_Rev2 1• User's_Manual_PAN1311_V20.xx_Rev1.1• User's_Manual_PAN1321_V20.xx_Rev3.14. FUNCTIONAL OVERVIEWThe figure below shows an overview of the Evaluation Board. If there is the need to connectyour μController to the EVB please de-solder R1, R2, R3, R4.For more details please refer also to the schematic in chapter Schematic.Figure 2 : Evaluation Board OverviewHardwareResetUART to USBConverter SectionFor interfacesdescription refer toschematicPower Supplysection