Panasonic PAW-PACR3 Instructions Manual

22 InstallingNote• Do not run the indoor/outdoor communication lines, input/output lines, and power cables through the sameconduit, or twist those cables together, or place the cables near one another. It can cause malfunction.• Install the main unit away from any sources of electrical noise.• Avoid installing in any locations where the unit may come into contact with water, or in any extremely humidlocations.• Avoid installing in any location that is subject to excessive vibration or physical impacts.1. Install PAW-T10 to each individual controlled indoor unit or to one single unit of each group (master orslave) by inserting the PCB holder into the appropriate holes.2. Connect the supplied T10 wire to the T10 connector of the indoor unit main PCB (CN061 yellow) and to theT10 connector of the PAW-T10 PCB (T10 white)Figure of installation to each Indoor unit