Panasonic PT-42PD3-P Operating Instructions Manual

Panasonic PT-42PD3-P Operating Instructions Manual Manual pdf 34 page image

34Select SIGNAL from the “SET UP” menu during RGB or PC input signal mode.Press to select each item.Press to adjust.SIGNAL [ PC ]SYNCPULL-IN RANGEH FREQ kHH & VNARROW31 5CLAMP POSITIONThe following operation methods are the same for both the SIGNAL [RGB]and SIGNAL [PC].SYNCSYNC H & VSYNC ON VIDEOSYNC ON GSetting RGB sync signalConfirm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT).H&V: The H and V sync signals are input from the HD/VD connector.ON G: Uses a synchronized signal on the Video G signal, which is inputfrom the G connector.ON VIDEO: Compatible with the scart plug (Europe)The composite video signal input from the VIDEO input terminal isused by dividing the sync signals.Sets the width for different frequencies.(This setting is the same for both SIGNAL [RGB] and SIGNAL [PC].)Setting PC sync signalConfirm that the input is set to PC INPUT (this setting is valid only for PC INPUT).H&V: The H and V sync signals are input from the HD/VD connector.ON G: Uses a synchronized signal on the Video G signal, which is input from the G connector.PULL IN RANGEPULL IN RANGEWIDEPULL IN RANGENARROWDisplays the H (Horizontal)/V (Vertical) frequencies.This display is valid only for RGB input and PC input.Display range:Horizontal 15.5 - 110 kHzVertical 48 - 120 HzH-FREQ (kHz)/V-FREQ (Hz)H - FREQ. kHzV - FREQ. Hz31.560.0SET UP for Input SignalsCLAMP POSITIONAdjusts the clamp position.The following operation methods are the same for “SIGNAL” menu duringCOMPONENT, RGB and PC input signal mode.Normally, these adjustments are set to appropriate levels, and therefore, do notneed to be altered.CLAMP POSITIONSIGNAL [ RGB ]SYNCPULL-IN RANGEH & VNARROWCLAMP POSITIONSIGNAL [ COMPONENT ]CLAMP POSITION