Panasonic PT-47WX54 Operating Instructions Manual

Also see for PT-53WX54: Operating instructions

Contents

Panasonic PT-47WX54 Operating Instructions Manual Manual pdf 16 page image

14 zREMOTE C ONTROL O PERATION (F OR MODEL PT-47WX34 ONLY)ENGLISHProgramming The Remote ControlThe Universal Remote Control can be programmed tooperate many manufacturers’ components, using thecomponent function buttons for VCR, DVD, CABLE orDBS. Follow the procedures for programming your RemoteControl with or without a code for the component.Note: Determine the manufacturer of the component and lookin the table for the code (found on page 15).Procedure1. Confirm that the external component is plugged in andoperating.2. Turn the component off.3. Press and together, for at least 5seconds. After 5 seconds, the illuminated mode(component) buttons will begin to flash. Release theACTION and POWER buttons.4. Press appropriate component button on the RemoteControl VCR, DVD, CABLE or DBS. The componentbutton will illuminate steadily and all others will go out.5. Enter the 3-digit component code using the RemoteControl numeric keypad (0 ~ 9 buttons). The componentbutton will blink twice.6. Press the Remote Control to test thecomponent. If the procedure was successful, thecomponent will turn on and the component key will blinktwice and then go out.Note: If the component does not operate with the RemoteControl, repeat the steps 3 through 6 using another code(some brands have multiple codes). If an incorrect codeis entered, or if the procedure takes longer than 30seconds, the programming will fail.Programming Without A CodeThis procedure searches all codes and is called the“sequence method.”1. Confirm that the external component is plugged in andon.2. Turn the component off.3. Press and together, for at least 5seconds. After 5 seconds, the illuminated mode(component) buttons will begin to flash. Release theACTION and POWER buttons.4. Press appropriate component button on the RemoteControl. The component button will illuminate steadilyand all others will go out.5. Press the button to set the remote control intothe step and set mode.6. Point the remote control towards the component.7. Press VOL X (the mode key will blink three times), thenpress the Remote Control button to test thecomponent. Continue this process until the proper codeis found. If the procedure was successful, the componentwill turn on.Note: Each time you press the VOL X button, make sure that thecomponent key blinks twice before pressing the POWERbutton.8. Once the device responds, press to store thecode. The mode (component) button will blink twice.Note: It may take many attempts before the correct codeis found. If you miss a code, press W VOL, then pressthe button to test the component.Component CodesThe Universal Remote Control is capable of operatingmany component brands after entering a code. Somecomponents may not operate because the codes are notavailable due to limited memory. The Universal RemoteControl does not control all features found in each model.Device Operates DefaultTV TV (Panasonic Only) Panasonic CodeDBS/CBL DBS STB & CBL STB (Preset) Panasonic DBS CodeVCR VCR (Preset) Panasonic CodeDVD DVD (Preset) Panasonic CodeACTIONPOWERPOWERACTIONPOWERPOWERWrite the code numbers from tables in this space.This will serve as a reference if you need to programyour Remote Control.VCR CABLE DVDDBSPOWERACTIONPOWER