Panasonic PT-51G35 Operating Instructions Manual

Also see for PT-51G35: Operating manual

Contents

INSTALLA TIONInstallationTelevision LocationThis unit can be used as an entertainment center. Consult your dealer for available options.0 Avoid excessive sunlight or bright lights, including reflections.0 Keep away from excessive heat or moisture. Inadequate ventilation may cause internalcomponent failure.£3 Fluorescent lighting may reduce remote control transmitting range.17 Keep away from magnetic equipment, including motors, fans and external speakers.Optional Cable ConnectionsShielded audio and video cables should be used between components. For best results:0 Use 75-ohm coaxial shielded cables.0 Use appropriate input and output connectors, that match your component connectors.E3 Avoid long cables to minimize interference.AC Power Supply CordCAUTION: TO PREVENT ELECTRIC SHOCK MATCHWIDE BLADE OF PLUG TOWIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE A PLUG WITH ARECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLYINSERTED TO PREVENT BLADE EXPOSURE. FOR SOME MODELS THAT ARENON-POLARIZED, THE USE OF AN AC ADAPTOR CONNECTOR MAYBE NECESSARY.PolarizedplugNon-PoladzedplugCable / Antenna ConnectionFor proper reception, either a cable or antenna connection is required.Cable Connection Incoming Cable fromConnect the cable supplied by your local cable company to ANT1connection on back of television. Select cable mode and ANT1 in SET UPmenu under Prog Chan (Program Channels).Note: A cable converter box may be required for proper reception.Check with your local cable company for compatibilityrequirements.Cable Company2!,75 OhmVHF/UHFon back of TVAntenna Connections• For proper receptionof VHF/UHF channels,an externalantenna is required. Forbest receptionan outdoorantenna is recommended•• Connect home antenna to ANT1 connectionon back of Incoming Cable fromtelevision. Select TV mode and ANT1 in the SET UP menuunder Prog Chan.-- -- Cable Presetf •Cable Mode is preset at the factory. Antennaiusers must change to TV mode and selectANT1 in the Set Up Menu under ProgChan.Home AntennaE1