Panasonic PT-60LCX64-K Service Manual

Also see for PT-60LCX64-K: Operating instructions

Panasonic PT-60LCX64-K Service Manual Manual pdf 84 page image

8 ADJUSTMENT PROCEDURES 1WHEN REINSTALLING THE PROJECTIONUNIT INTO THE UNIT AT THE USER’SLOCATION:The following ADJUSTMENT of the Projection Unit must beperformed.a. Mechanical Picture Position Adjustmentb. Focus AdjustmentNote:Perform this adjustment only if necessary. (Normally, it willnot be necessary.)c. Electrical Picture Position AdjustmentPreparation of ADJUSTMENT:1. Install all parts except the Front Cover Unit and the OpticalCover.Fig. M1-1Note:When the rear cover is disassembled, the screen can bemoved back and forth, which could affect the video displayvertical position. This could also cause the vertical adjust tobe at or near its limit.Only try the picture position adjustment with the rear coverassembled!2. Turn the power on.3. Press and hold the VOLUME DOWN button on the unit andthe RECALL key on the remote for more than 5 seconds inpower on condition. The unit will go into Work Mode.("WORK MODE" will appear on the screen.)Fig. M1-2ProjectionUnit(With Front Cover Unit and Optical Cover removed)C - C O R / G A M / W - B A LP U S H R E C A L L 5 S E CW O R K M O D E4. 1) Then, press and hold the VOLUME DOWN button onthe unit and the SWAP key on the remote for more than1 second. The unit will go into the Factory Adjust Mode.(FACTORY ADJUST menu will appear.)Fig. M1-32) Then, press the CH UP/DOWN key on the remote toselect "OTHER" on menu and press the OK key.(OTHER menu will appear.)Fig. M1-45. Press the VOLUME UP/DOWN key on the remote.(Focus screen will appear.)F A C T O R Y A D J U S T 1 / 1M : 0 0 3 0 2 8 S : 0 0 2 0 0 5 0V I D E O A D JS O U N DF A NO T H E RP A R T I A LE D I DD E F A U L T S E T( S E L F C H E C K )O P T H P O S I 0 7O P T V P O S I 0 3(OTHER menu 1/1)O t h e r 1 / 1O P T H P O S I 0 7O P T V P O S I 0 3F I L T E R D E T 3 0F P : 6 3 0 6 6 3 P R O T E CG C : 0 4 0 7 1 6To release this mode:1. After completing the ADJUSTMENT, press the CH UP/DOWN key on the remote to return to the OTHER menu.2. Then, press RECALL key twice to return to Work Mode, andpress and hold the VOLUME DOWN button on the unit andthe RECALL key on the remote for more than 5 seconds.Alternatively, turn off the power.3. Then, install the Optical Cover with the 2 Screws and theFront Cover Unit.PT-60LCX64-K84