Panasonic PT-D5000U Operating Instructions Manual

Contents

Panasonic PT-D5000U Operating Instructions Manual Manual pdf 19 page image

ENGLISH - 19 Basic OperationProjecting Switching on the projectorWhen using an optional lens, install a projection lensbefore switch on the projector.1. Connect the supplied power cord (220 - 240 V AC,50 Hz/60 Hz) to the AC IN terminal.2. Remove the projection lens cover from the lens.3. Switch the POWER switch on that is on the side of theprojector. The power indicator lamp on the projector will flash in red.After a short period, the indicator will illuminate and theprojector will enter standby mode.4. Press the POWER ON button The power indicator lamp illuminates in green and soon theimage is projected on the screen.. Making adjustment and selectionIt is recommended that the projector be allowed to warmup for at least 30 minutes before any adjustments aremade to the focus.1. Roughly adjust the focus of the lens.2. Select and set the projection scheme ofINSTALLATION and COOLING CONDITION settings inPROJECTOR SETUP menu.3. Select the input signal by pressing the INPUT SELECTbuttons.4. Adjust the vertical tilt of the projector with the front legadjusters.5. Adjust the shift position of the projection. If the input signal is RGB signal, additionally press theAUTO SETUP button to adjust the position of the image.6. Zoom the lens so the image fills the screen.7. Readjust the focus.8. Readjust the zoom so that the image size fits in thescreen. Adjusting focus, zoom and shiftProjecting a imageNOTE:• If the projector is powered up at about 0 °C (32 °F), a warm-up period of approximately 5 minutes may be necessary tostart projection. The temperature monitor (TEMP) lamp lightsup during the warm-up period. When the warm-up iscompleted, the temperature monitor (TEMP) lamp turns offand the image is projected on the screen.• If the temperature of the operating environment is low andwarm-up takes more than 5 minutes, the projector will judgethat a problem has occurred and the power will be turned offautomatically. If this happens, increase the temperaturearound the projector so that it is 0 °C (32 °F) or higher, andthen turn on the POWER switch and press the POWER ONbutton again.POWER switch AC IN terminalPOWER ON buttonControl buttons of theprojectorPressing the LENS button changes thesetup screen in order of FOCUS, ZOOMand SHIFT. Press F G I H to adjust.Remote control buttonsPress FOCUS, ZOOM or SHIFT buttonto display the setup screen. Press F GI H to adjust.CAUTION:• Be careful not to catch your fingers between the lens andshroud when shifting the lens.NOTE:• The setup screen will be displayed with the optional fixed lensthough, it will not be functioning.• Pressing F G I or H for 3 seconds or more, performancethe adjustment faster.LENS buttonINPUT SELECT buttons