Panasonic PT-D5500E Operating Instructions Manual

Also see for PT-D5500E: Operating instructions Brochure & specs Service manual

Contents

Panasonic PT-D5500E Operating Instructions Manual Manual pdf 22 page image

22ProjectionPowering up the projectorRemove the lens cover.Connect the supplied power cable.(220 - 240~ V AC, 50 Hz/60 Hz)Press the “I” marked side of the MAINPOWER switch to turn on the power.The power indicator lights up red, and the projector isplaced in the standby mode.Press the “l” button. [on the main unitor the remote control]The power indicator illuminates in green and soonthe image is projected on the screen.Making adjustment andselectionRoughly adjust the focus of the lens.(Refer to page 24.)Press the LENS button on the main unit or theremote control unit to display a focus adjustmentscreen. Pressing buttons to adjust theimage into focus.Select and set the projection scheme.(Refer to page 34.)Select the input signal by pressing theinput selector button to toggle throughRGB1, RGB2, VIDEO, S-VIDEO and DVI.[on the main unit or the remote control]Turn the feet, and adjust the tilt of themain unit in the front and rear or leftand right.Use the lens left/right adjustment dial toadjust the direction of the lens. (page 24)VDSYNC/HDB/P BG/YRR/PSEREMOTE 1 REMOTE 2 IN INRGB 1 INVIDEO IN S-VIDEO ININ OUTLAMP1 LAMP2 POWERTEMPD LPPress the LENS button three times toadjust the lens shift. (Refer to page 24.)Press the AUTO SETUP button if theinput signal is RGB signal. [on the mainunit or the remote control]Fit the image size to the screen size.Press the LENS button twice and adjust the zoomof the lens on the lens zoom adjustment menu.Press the LENS button and adjust thefocus of the lens on the lens focusadjustment menu.Display the zoom adjustment menuagain and adjust the zoom of the lens tofit the image size to the screen size.(Refer to page 24.)• If the projector is powered up at about0˚C, a warm-up period of approximatelyfive minutes may be necessary to startprojection.The temperature monitor (TEMP) lightsduring the warm-up period.When the warm-up is completed, thetemperature monitor (TEMP) turns off andthe image is projected on the screen.• If the surrounding temperature is very lowand the warm-up period exceeds fiveminutes, the control determines it as anabnormal condition and turns off thepower automatically. If this happens, raisethe surrounding temperature to 0°C orhigher and then turn the main power “on”and turn the power “on” (|).Note