Panasonic PT-DW5000UL Operating Instructions Manual

Contents

Panasonic PT-DW5000UL Operating Instructions Manual Manual pdf 40 page image

40Using the REMOTE 2 terminal provided on the side of themain unit, it is possible to operate the projector from acontrol panel etc. furnished in a distant location whereinfrared remote control signal cannot be received.Pin assignments and controlBe sure to short-circuit Pins andwhen controlling.Using the REMOTE 2 terminalD-Sub 9-pin (female)external appearance• The following buttons on the remotecontrol and the operation area of theprojector can no longer be operated whenpins and are shorted: POWERbutton and SHUTTER button.Neither will it be possible to use theRS232C commands or network functionscorresponding to these functions.• If you short pin and pin , and alsoshort one of the pins from to andpin , then the following buttons on theprojector operating area and the remotecontrol can no longer be operated:POWER, RGB1, RGB2, DVI, VIDEO, S-VIDEO and SHUTTER buttons.Neither will it be possible to use theRS232C commands or network functionscorresponding to these functions.NoteExample of a control panel layoutProjector set up in a meeting roomControl panel locatedin a different roomSTANDBY ONRGB1 VIDEORGB2 S-VIDEOLAMPRemoteterminalExternalcontrolRemote terminal/External controlDVINames of terminalsGNDPOWERRGB1RGB2VIDEOS-VIDEODVISHUTTERRST / SETOpen (H)OFFOtherOtherOtherOtherOtherOFFControlled byremote controlShort (L)GNDONRGB1RGB2VIDEOS-VIDEODVIONControlled byexternal contactCable specificationsControl commandsWhen controlling the projector from a computer, thefollowing commands are available:• To connect the computer to theSERIAL terminal, prepare anadequate communication cable thatfits to your personal computer.AttentionRemarksCommand Function ofcommandTo confirm that the power isON, use a “Power query”command.Parameter000 = STANDBY001 = Power “ON”ParameterVID = VIDEO SVD = S-VIDEORG1 = RGB1 RG2 = RGB2DVI=DVIParameter0 = DUAL1 = SINGLE2 = LAMP 13 = LAMP 2Parameter0 = DUAL1 = SINGLE2 = Only LAMP 1 is on3 = Only LAMP 2 is onParameter0 = HIGH, 1= LOWPower “ON”Power“STANDBY”Power querySwitch inputmodesQuery foractivelamp modeActive lampmodeLamp powersettingPONPOFQPWI I SQSLLPMOLP“SINGLE” will usethe lamp (LAMP 1or LAMP 2) withshorter operatinghours.Projector123456789NCNCNCNCComputer(DTE specifications)123456789NCNCNCNC• If you need a detailed command list,please contact your dealer.NoteUsing the serial terminals