Panasonic PT-LB10NTU - Mobile Proj XGA 2000 Lumens 4.9LBS Cross Platform Wrls Operating Instructions Manual

Also see for PT-LB10NTU - Mobile Proj XGA 2000 Lumens 4.9LBS Cross Platform Wrls: User guide Operating instructions Specifications Operating instructions Operating instructions

FREEZE SHUTTERINDEXWINDOWPROJECTORVOLUME D.ZOOMSTDVIDEOINPUTPOWERRGBMENUAUTOSETUPENTER#$%E NGLISH -27 Basic OperationTurning off the powerPower indicatorPower indicatorPower indicator statusRed Illuminated The projector is in standby mode and image projectionis possible by pressing the POWER button.A picture is being projected.The lamp is cooling down after the power is turnedoff. (The cooling fan is operating.)The projector is preparing for projection after thepower is turned on while the power indicator isilluminated orange. (After a short period, a picturewill be projected.)The projector is preparing for projection after thepower is turned on while the power indicator isilluminated red. (After a short period, a picture will beprojected.)FlashingIlluminatedIlluminatedFlashingGreenOrangeProjector statusPress the POWER button.B“POWER OFF” is displayed on thescreen.Press the II or HH button to select “OK”, andthen press the ENTER button.BThe lamp unit will switch off and the picture will stop being projected.(The power indicator on the projector will illuminate orange while thecooling fan is still operating.)NOTE:B You can also turn off the power by pressing the POWER button twice orby holding it down for at least 0.5 seconds.B When the projector is in standby mode (the power indicator on theprojector is illuminated red), the projector continues to draw approximately6 W of power even when the cooling fan has stopped.#$%P O W E R O F FO K C A N C E LPowercordDirect power off functionYou can disconnect the power cord during projection or immediately afteruse and move the projector. The cooling fan will operate by the internalpower supply to cool down the lamp.B When this function is used, it may take more time for the lamp to turn backon again compared to when the lamp cools down with the power cordconnected.B Do not put the projector in a bag while the cooling fan is operating.Disconnect the power cord after the powerindicator on the projector illuminates red.26-ENGLISHCAUTIONIf not using the projector for an extended period of time, disconnect thepower cord plug from the wall outlet.B If dust builds up on the power cord plug, the resulting humidity maydamage the insulation, which could result in fire.B This projector continues to draw approximately 6 W of power even whenthe power is turned off.