BA56-ENGLISHLamp unit replacement procedure# Disconnect the power cordfrom the projector by followingthe procedure on page 26, andcheck that the area around thelamp unit has cooled down.$ Use a Phillips screwdriver toturn the lamp unit cover fixingscrews at the bottom of theprojector, and then remove thelamp unit cover.% Use a Phillips screwdriver toloosen the two lamp unit fixingscrews until the screws turnfreely. Then hold the handle ofthe lamp unit and gently pull itout from the projector.& Insert the new lamp unit whilemaking sure that the directionof insertion is correct, and thenuse a Phillips screwdriver tosecurely tighten the lamp unitfixing screws.When inserting the new lampunit, be sure to push it in at thepoint A and B.LAMP indicatorOn-screen displayIlluminates red duringimage projection andstandby mode.Displayed for 30seconds. Pressing anybutton will clear thedisplay.More than 1 800 hoursRemains displayed untilany button is pressed.More than 2 000 hoursNOTE:B If the lamp usage time has passed 2 000 hours (when “LAMP POWER” hasbeen set to “HIGH” and when “AI” has been set to “OFF”), the projector willswitch to standby mode after approximately 10 minutes of operation. Thesteps ) to - on the next page should thus be completed within 10 minutes.HandleLamp unit coverLamp unit cover fixing screwsLamp unit fixing screws
