Panasonic PT-LB20NTU User Manual

Also see for PT-LB30 - XGA LCD Projector: Operating instructions

Contents

Panasonic PT-LB20NTU User Manual Manual pdf 44 page image

44WEPOFF : Check this when the WEP is not registered in the AP.ON : Check this when the WEP is registered in the AP, and make thefollowing settings.AuthenticationOPEN : Check this when the AP authentication is Open System.SHARED : Check this when the AP authentication is Shared Key.(If this is performed in AdHoc mode, select OPEN.However, some computers may require connection bySHARED authentication.)KEYLENGTHSet the length of the WEP KEY.64 Bit : Alphanumeric – 5 characters; Hexadecimal – 13 characters128 Bit : Alphanumeric – 13 characters; Hexadecimal – 26charactersDEFAULT KEY IDSet 1 – 4 numerals for the default WEP KEY.INPUT FORMATCHARACTER : Check this when the input is alphanumeric.HEXADECIMAL: Check this when the input is hexadecimal code.KEY 1 – 4Set these to match the WEP KEY registered in the AP.Using WebBrowser (cont.)3 Click [Next].The above settings will be registered in the user settings of the projector. Making the above settings effectiveSelect [NETWORK] in the network menu of the projector (see page 28), and use the[ ] buttons to select [USER] and press the [ENTER] button.Notes:• The projector supports only 64 bit and 128 bit WEP codes.• WPA and WPA2 are not supported. However, image and audio data are allencrypted using AES, so essential data are protected.