Panasonic PT-LB60NTE Operating Instructions Manual

Also see for PT-LB55NTE: Function guide Operating instructions Operating instructions Operating instructions

Contents

Panasonic PT-LB60NTE Operating Instructions Manual Manual pdf 51 page image

E NGLISH -51 Adjustments and settingsAUTO SETUPThis should normally be set to“AUTO”.AUTO“AUTO SETUP” will be carried outwhen the input signal is changed toRGB.BUTTON“AUTO SETUP” will function onlywhen you press the AUTO SETUPbutton.SIGNAL SEARCHThis should normally be set to “ON”.ONWhen the power is turned on and“AUTO SETUP” is running, theprojector detects which signals arebeing input, and uses these signalsfor projection.(If a picture is being projected, thesignal source is not automaticallychanged.)OFFUse this setting when you do notwant the signal source to bechanged automatically when thepower is turned on and “AUTOSETUP” is running.POWER OFF TIMERIf no signal is input to the projectorfor the duration of the period youset, the projector will return tostandby mode. The period can beset from 15 minutes to 60 minutes in5 minute intervals. If you don’t usethis feature, set it to “DISABLE”.DIRECT POWER ONThis sets the projector’s start upstatus for when the mains lead isconnected.OFFThe projector will start from thesame status as when the mainslead was disconnected. If the mainslead was disconnected duringprojection when the projector wasused the last time, projection willstart after the mains lead isconnected.ONThe projection will start after themains lead is connected.CONTROL PANELTo disable the buttons on theprojector, set “CONTROL PANEL”to “INVALID”. A confirmation screenwill then be displayed. Select “OK”by using I or H button. To use thebuttons on the projector, set to“VALID” by using the remote controlunit.