ENGLISH - 30SettingsPICTURE menuDepending on the projection environment, you can usethese preset parameter settings to optimise imageprojection. Press I H to cycle through the options.You can adjust the contrast of the projected image.Adjust the BRIGHTNESS in advance if necessary.You can adjust the brightness of the projected image.You can adjust the color saturation of the projectedimage. (Available with signals of VIDEO/S-VIDEO/YPBPR only)You can adjust the skin tone in the projected image.(Available with signals of VIDEO/S-VIDEO/YPBPR only)You can adjust the sharpness of the projected image andthe adjustable range depends on the input signal.You can adjust the white balance of the projected image.Press I H to cycle through the options.STANDARD Balanced whiteHIGH More bluishLOW More reddishYou can keep the projected image bright and vivid evenin well-lit rooms where the ambient light sources cannotbe controlled, such as when a door opens or whenwindow coverings fail to block out sunlight.AUTO: Automatic adjustmentON: ActiveOFF: DeactivePICTURE MODENATURAL Reproduces the original color ofthe imageSTANDARD Setting for a general imageDYNAMIC Bright and sharp settingBLACKBOARDSetting for when projecting on ablackboardSee “BLACKBOARD” onpage 36.NOTE:• The default setting varies according to the selectedsignal.• It may take for a while until the selected mode isstabilised.CONTRASTBRIGHTNESSMENU RETURNRemote control Control panelSee “Navigating through the MENU” on page 27.See “Main menu and Sub-menu” on page 28.HigherLowerBrighterDarkerCOLORTINTSHARPNESSCOLOR TEMPERATUREDAYLIGHT VIEWNOTE:• Do not cover the Ambient Luminance Sensor (ALS) ofthe projector. See “Ambient Luminance Sensor (ALS)”on page 12.• AUTO is not available when INSTALLATION setting inOPTION menu is set to REAR/DESK orREAR/CEILING.DarkerLighterMoregreenishMorereddishMoresharpLesssharp