Panasonic PT-LX300E Operating Instructions Manual

Contents

Panasonic PT-LX300E Operating Instructions Manual Manual pdf 26 page image

Powering ON/OFF26 - ENGLISHBasic OperationPowering On the ProjectorConnect the power plug to the power outlet.1 ) Enter Standby status when the indicator is lighting / blinking in red.zPress the <2 ) v/b> button on the control panel or the remote control.When the indicator lights up in green, the lamp is on.zStartup screen is displayed for about 10 seconds, then the image will be projected.zORNoteIf the power is disconnected due to the power breaker during projection at the last use, ON(G)/STANDBY(R) indicator willzlight in green automatically at the next startup and the image will be projected.Powering Off the ProjectorPress the <1 ) v/b> button on the control panel or the remote control.The following message appears.zMessage will disappear after about 30 seconds when there is no operation.zPress the <2 ) v/b> button again.The projection stops and the indicator on the projector flashes up in red. (Fan iszstill spinning.)Wait until the indicator lights / blinks in red (The fan stops3 )spinning).The projector enters standby mode when the indicator lights / blinks in red.zNoteDo not turn on the power and project images immediately after turning the projector off. Turning on the power while thezlamp is still hot may shorten the lamp life.Make sure that the projector is cool enough if you want to pack it for transportation and storage.z