Panasonic PT-LX300EA Operating Instructions Manual

Panasonic PT-LX300EA Operating Instructions Manual Manual pdf 38 page image

Position38 - ENGLISHSettingsV PositionShift the projected image position vertically.Press ▲▼ to select [V Position].1 )Press ► to display the adjustment2 )dialog box.Press ◄► to adjust the level.3 )NoteDuring Computer input signal, [V Position] can bezadjusted.Digital ZoomAdjust the magnification of the image. Magnificationcan be set from 1.0x to 2.0x in 0.1 increments.Press ▲▼ to select [Digital Zoom].1 )Press ► to display the adjustment2 )dialog box.Press ◄► to adjust the level.3 )NoteWhen the [Digital Zoom] is in the enlarge status, exits thezmenu screen and the [Zoom] picture will display at thebottom left of the screen. This indicates the zoomfunction is in use.Under the enlarge status, press ▲▼◄► to move thezenlarged image.If the input signal is changed under the enlarge status,zthe magnification of [Digital Zoom] will be reset.V KeystoneThis function is used to adjust keystone distortion ofthe projected image.Press ▲▼ to select [V Keystone].1 )Press ► to display the adjustment2 )dialog box.Press ◄► to adjust the level.3 ) Use the (▲▼) buttons on thezremote control to adjust.Operation Screen imagePress the ▲► onthe remote controlor the ► on thecontrol panel toadjust the upper ofthe keystone.Press the ▼◄ onthe remote controlor the ◄ on thecontrol panel toadjust the bottom ofthe keystone.NoteThe adjusted keystone distortion will store automaticallyzeven when the signal is interrupted or the AC power cordis plugged out or turned off the projector.When the larger amount of keystone correction, thezpicture quality will degrade and it will get harder to focuswith more correction. Set the projector so the correctionwill be as small as possible.When keystone correction is performed, the screen sizezwill also change.Part of Closed caption may not be displayed when highzcompensation values are set in [V Keystone].Ceiling MountThis function is used to project the image from aceiling-mounted projector.Press ▲▼ to select [Ceiling Mount].1 )Press ► to display the choosing dialog2 )box.Press ◄► to select the desired item.3 )Front When setting on a desk/floor andprojecting from forward.FrontCeilingWhen mounting on the ceiling andprojecting forward.RearWhen setting on a desk/floor andprojecting rear (Using translucentscreen).RearCeilingWhen mounting on the ceiling andprojecting from rear (Using translucentscreen).