Panasonic PT-P1SDU Service Manual

Also see for PT-P1SDE: Operating instructions Service manual

fixing the A-P.C.Board block as they are removed.7. Adjust the convergence according to the section 7.4."Convergence Adjustment".8. After the adjustment, while paying attention not to vary theadjusting result, tighten the 2 screws fixing the panelattachment with a hexagon head wrench.Note:· Prepare a hexagon head wrench processed short.9. Reassemble the projector as it was.6.14. LCD Panel DiscriminationID-tag seal color LCD panelRed LCD panel (R)Blue LCD panel (B)(No seal) LCD panel (G)· Since the ID-tag seal is pasted to the FPC of LCD Panel,(R), (G) or (B) can be easily identified by the color of theseal.· Finally, identify the panel color by the part number printedon the FPC.6.15. LCD Panel Combination· Part number is printed on the FPC of LCD Panel.· When replacing LCD Panel, use a component which hasthe same part number as the original.LCDpanelCombination1 Combination2R L5BDAXN00079(L3P06S-45G10)L5BDAXN00082(L3P06S-46G10)G L5BDAXN00083(L3P06S-46G10)L5BDAXN00080(L3P06S-45G10)B L5BDAXN00081(L3P06S-45G10)L5BDAXN00084(L3P06S-46G10)6.16. Replacement of IncidencePolarizer (B)1. Remove the A-P.C.Board block according to the steps 1through 4 in the section 6.4. "Removal of J-P.C.Board".2. Unscrew the 2 screws and remove the LCD block.Note:· Be careful not to touch the surface of prism and LCDpanel.3. Unscrew the 2 screws.4. Remove the analysis case (upper) while expanding the 2hooks of it outside.16PT-P1SDU / PT-P1SDE / PT-P1SDEA