Setting56- ENGLISHSettingsPress ► or 2)access the submenu.ModeJPress ▲▼ button to select one mode1)among the items as below.Count upThe P-timer display 000:00 appearson the screen and the count upstarts (000:00-180:00)Count downThe time set in the Timer settingappears on the screen and thecountdown starts.TimerJPress ▲▼ to select [Timer] and then1)press the Press▲▼ to set the [Timer](1-180 Min).2)Timer is available in Count down only. Factoryzdefault value is 10 Min.ExecuteJPress ▲▼ to select one among the1)items as below and then press theStartIt executes the count up or countdown function.*1ResetReset the P-timer values.*2ExitTo exit the P-timer operation.Press the *1:indication changes into Stop. To stop Count upor Count down, press the Stop on the screen menu, then the indicationchanges into Restart. Press the button at Restart to resume Count up or Countdown.Press the *2:the following value:Count up"000:00"Count downTimer that you setAttentionTo stop the P-timer function, press the zbutton.To cancel the P-timer, press and hold the zbutton for a few seconds.Closed caption[Only for NTSC, 480i input]Press ▲▼ to select [Closed caption].1)Press ► or the 2)enter the submenu.Closed captionJPress ▲▼ to select [Closed caption]1)and then press the Press ▲▼ to select Off, CC1, CC2,2)CC3 or CC4.ColorJPress ▲▼ to select [Color] and then1)press the Press▲▼ to select color or white.2)AttentionThe closed caption is mainly used in the north America.zThis function shows the text information contained in theimage signal. Captions may not be displayed on somedevices or software.You can select [Closed caption] when NTSC or 480izsignals are input.Part of characters may not displayed when highzcompensation valued are set in [Keystone].Closed captions are not displayed while the menu screenzappears.