-72-Each indicator on the projector indicates the operating status of the projector. If you find the un-expected operationduring usage, check the projector's operation with the tables below. The indicators also let you know the maintenancesign. To use the projector in the best performance for a long period of time, take an adequate maintenance accordingto the indicator status.Indicators and projector conditionTroubleshootingIndicator Lighting in yellowStatus The projection lamp reaches its end of life.Check Is there a Lamp replacement icon appears on the screen?Remedy Replace the lamp unit.LAMP indicatorIndicator Lights in red. Blinks in red.Status The projector detects an abnormalcondition and cannot be turned on.If the temperature within the projector becomes toohigh, the indicator will start to flashslowly.If the temperature within the projector becomes evenhigher, the indicator will flash faster,and the indicator blinks inorange. When the projector has cooled inside andreturned to operating temperature, it will turn offautomatically.Check Unplug the AC power cord and plugit again to turn on the projector.- Did you provide appropriate space for the projectorto be ventilated? Check the installing condition tosee if the air vents of the projector are not blocked.- Has the projector been installed near an Air-Conditioning/ Heating Duct or Vent?- Are the filters clean?RemedyIf the projector is turned off again,unplug the AC power cord andcontact the dealer or the servicecenter for service and checkup.- Provide good installing condition to your projector.- Move the installation of the projector away from theduct or vent.- Replace filters.WARNING indicatorIndicator status StatusNo illumination or flashing The power cord is unplugged.RED LitThe power cord is pluggedThe projector is in stand-by mode, after the cooling is completed.ORANGE FlashingThe projector is cooling down. The projector cannot be turned on until cooling iscompleted and the indicator stops blinking.The temperature inside the projector is abnormally high. And the indicator also blinks in red. The projector cannot be turned on until cooling iscompleted and the indicator stops blinking.GREENLit Projecting.FlashingThe projector is in stand-by status with [Power management] function.The projection lamp will be turned on if the input signal is reconnected or anybutton on the control panel or remote control is pressed.ON(G)/STANDBY(R) indicatorNote:-If indicator persists to light or blink after taking these measurements, please contact your dealer for repair ser-vices. Do not leave the projector on. It may cause an electric shock or a fire hazard.- The projector detects an abnormal condition and cannot be turned on. Unplug the AC power cord and plug it again to turn onthe projector. If the projector is turned off again, unplug the AC power cord and contact the dealer or the service center for ser-vice and checkup. Do not leave the projector on. It may cause an electric shock or a fire hazard.
