Panasonic PV-GS19 Operating Instructions Manual

Also see for Digital Paimcorder MultiCam PV-GS19: Operating instructions Operating instructions Operating instructions

Contents

Panasonic PV-GS19 Operating Instructions Manual Manual pdf 15 page image

15Before Using[VCR1]:Press the [ǿŹ] Button and [ Ŷ ] Buttonsimultaneously. 1[VCR2]:Press the [Żǿ] Button and [ Ŷ ] Buttonsimultaneously. 2• When the battery in the Remote Control is replaced,the mode is automatically reset to [VCR1] Mode. Setup on the CamcorderSet [ REMOTE] on the [ SETUP] Sub-Menu tothe desired Remote Control Mode. (pp. 22, 23) Setup on the Remote Control12Power SupplyUsing the AC Adaptor1 Connect the DC Cable to the Camcorder.2 Connect the DC Cable to the AC Adaptor.3 Connect the AC Cable to the AC Adaptorand the AC Jack.• Before connecting or disconnecting thepower supply, set the [OFF/ON] Switch 28 onthe Camcorder to [OFF] and make sure that[POWER] Lamp 32 is not lit. (p. 18)Using the Battery• We recommend using a Panasonic Battery.• We cannot guarantee the quality of this Camcorderwhen batteries from other companies are used.1 Attach the Battery to the AC Adaptor andcharge it.2 Put the Battery on the Battery Mount byaligning the mark, and then securely plug itin.Before use, fully charge the Battery.• Since the Battery will not be charged whenthe DC Cable is connected to the AC Adaptor,disconnect it from the AC Adaptor.• The [CHARGE] Lamp lights up, and chargingstarts.• When the [CHARGE] Lamp goes off, charging iscompleted.• When the battery is completely discharged, the[CHARGE] Lamp blinks at first, but the battery ischarged normally. When the temperature of thebattery is too high or low, the [CHARGE] Lampblinks and the charging time becomes longerthan usual.3 Attach the charged Battery to theCamcorder.• For other notes concerning this item, see page 59. Disconnecting the Power SourceSet the [OFF/ON] Switch 28 to [OFF], and whilesliding the [BATTERY RELEASE] Switch 39 ,remove the Battery downward or DC Cable.• When attaching or removing Battery, set the[OFF/ON] Switch to [OFF] and make sure the[POWER] Lamp is not lit.2839• Hold down the battery with your hand so it doesnot fall.