Panasonic PV-L352 Operating Instructions Manual

Also see for Palmcorder PV-L352: Operating manual

Panasonic PV-L352 Operating Instructions Manual Manual pdf 9 page image

9Getting StartedSupplying PowerTo use battery refresh, insert Battery on ACAdaptor (see steps 1~2 above), then pressBATTERY REFRESH.The REFRESH Lamp lights, then goes out whendischarge is complete. Battery charging will thenstart automatically.If BATTERY REFRESH is pressed by mistake,remove Battery from AC Adaptor and reinsert itfor normal charging.Note:• Charging takes about 5 hours when BatteryRefresh is used.• Battery will not operate in extremely hightemperatures.Note:• Charging takes about 1 hour.• While the DC Power Cable (supplied) is connectedto the AC Adaptor, the Battery cannot be charged.• After charging 5 times, use Battery Refresh featureas explained below.• Battery life gradually decreases after repeated useand recharging. If operation time becomes veryshort even after a sufficient charge, discard Batteryproperly (page 10).Charge Battery Pack fully before use. 1 Plug in AC Adaptor.POWER Lamp lights.2 Insert Battery.A Align left side of Battery with left edge ofAC Adaptor.B Press Battery down and slide in directionof arrow.The CHARGE Lamp flashes, then stays litwhen charging is complete.3 Remove Battery.Slide Battery to the left and lift off.Charging the Battery PackBattery RefreshThis feature completely dischargesBattery before recharging begins.Use after every 5 charges for optimumBattery performance.A fully charged Battery provides a maximum of about 1 hour 10 minutes of continuous use(LCD monitor off) or about 55 minutes (LCD monitor on). Actual time may vary due tooperating conditions. Using the Built-in Light decreases operating time.Using the Battery PackA Attach Battery.a Insert top of Battery into top of mountingsurface.b Press and snap into place.B Remove Battery.Slide BATTERY RELEASE and removeBattery.bABaPOWERLampCHARGELamp12 3A(Top View)BBATTERYREFRESHREFRESHLamp02.L352 Getting p09-16 01.12.10, 4:22 PM9