Panasonic Palmcorder IQ PV-IQ404 Operating Instructions Manual

14. Lightning -- For added protection of this video unitreceiver during a lightning storm, or when it is leftunattended and unused for long periods of time, unplug itfrom the wall outlet and disconnect the antenna or cablesystem. This will prevent damage to the video unit due tolightning and power-line surges.15. Power Unes -- An outside antenna system should not belocated in the vicinity of overhead power lines or otherelectric light or power circuits, or where it can fall intosuch power lines or circuits. When installing an outsideantenna system, extreme care should be taken to keepfrom touching such power lines or circuits as contact withthem might be fatal.16. Overloading -- Do not ovedoad wall outlets andextension cords as this can result in a risk of fire orelectric shock.17. Objects and Liquids -- Never push objects of any kindinto this video unit through openings as they may touchdangerous voltage points or Short out parts that couldresult in a fire or electric shock. Never spill liquid of anykind onto the video unit.18. Servicing -- Do not attempt to service this video unityourself as opening or removing covers may expose youto dangerous voltage or other hazards. Refer all servicingto qualified service personnel.19. Damage Requiring Service -- Unplug this video unit fromthe wall outlet and refer servicing to qualified servicepersonnel under the following conditions:a. When the power-supply cord or plug is damaged.b. If any liquid has been spilled onto, or objects havefallen into the video unit.c. If the video unit has been exposed to rain or water.d. If the video unit does not operate normally byfollowing the operating instructions. Adjust only thosecontrols that are covered by the operatinginstructions, as an improper adjustment of othercontrols may result in damage and will often requireextensive work by a qualified technician to restorethe video unit to its normal operation.e. If the video unit has been dropped or the cabinet hasbeen damaged.f. When the video unit exhibits a distinct change inperformance -- this indicates a need for service.20. Replacement Parts -- When replacement parts arerequired, be sure the service technician has usedreplacement parts specified by the manufacturer or havethe same characteristics as the original part.Unauthorized substitutions may result in fire, electricshock or other hazards.21. Safety Check-- Upon completion of any service orrepairs to this video unit, ask the service technician toperform safety checks to determine that the video unit isin safe operating order.USE & LOCATION• TO AVOID SHOCK HAZARD ... Your Camcorder and power supply should not be exposed to rain or moisture.Do not connect the power supply or operate your Camcorder if it gets wet. Your Camcorder has been designedfor outdoor use, however it is not designed to sustain direct exposure to water, rain, sleet, snow, or a directsplashing from a pool or even a cup of coffee. Do not attempt to disassemble this unit. There are no userserviceable parts inside. Unplug your Camcorder from the power supply before cleaning.• DO NOT AIM YOUR CAMCORDER AT THE SUN OR OTHER BRIGHT OBJECTS° DO NOT EXPOSE YOUR CAMCORDER TO EXTENDED HIGH TEMPERATURE ... Such as, in directsunlight, inside a closed car, next to heater, etc... This action could permanently damage the internal parts ofyour Camcorder.• AVOID SUDDEN CHANGES IN TEMPERATURE ... If the unit is suddenly moved from a cold place to a warmplace, moisture may form on the tape and inside the unit.° DO NOT LEAVE YOUR CAMCORDER OR THE POWER SUPPLY TURNED ON WHEN NOT IN USE• STORAGE OF YOUR CAMCORDER ... Store and handle your Camcorder in a manner that will not subject it tounnecessary movement (avoid shaking and striking). Your Camcorder contains a sensitive pick-up device whichcould be damaged by improper handling or storage.CARE• TO CLEAN YOUR CAMCORDER ... Do not use strong or abrasive detergents when cleaning your Camcorderbody.• TO PROTECT THE LENS ... Do not touch the surface of the lens with your hand. Use a commercial camcorderlens solution and lens paper when cleaning the lens. Improper cleaning can scratch the lens coating.° TO PROTECT THE FINISH OF YOUR CAMCORDER ... Before handling your Camcorder, make sure yourhands and face are free from any chemical products such as suntan lotion as it may damage the finish.4