Panasonic RX-CS710 User Manual

Also see for RX-CS710: Operating instructions

RADIO TAPE PLAYBACK1. Set the Function Selector to “RADIO”’.2. Set the Band Selector to the desired radio band.3. Tune in your favourite station using the Tuning Control.4. Adjust the Volume and Graphic Equalizer Controls tothe desired settings.(Refer to “Graphic Equalizer”.)5. The radio can be turned off by setting the FunctionSelector to “TAPE/[qffT.Notes;•To receive FM stereo broadcasts, set the FM ModeSelector to “STEREO”.The FM Stereo Indicator will light during stereobroadcasts.• If FM stereo reception is poor (excessive noise, FMStereo Indicator flickers), set the FM Mode Selectorto “MONO”.This will reduce the noise and provide clearreception; however, the broadcast will not be heardin stereo.■ Graphic EqualizerIt aliows you to tailor the frequency response of the unit tocompensate for room acoustics and other factors whichaffect frequency response. The overall tone can be alteredby adjusting the five controls which control the followingfrequency bands:100 Hz, 330 Hz, 1 kHz, 3.3 kHz, 10 kHz.Positioning the control to the “+” side of the detent willamplify the corresponding frequency band; the sidewill attenuate it.1. Open the Cassette Compartment cover by pressing theStop/Eject Button. Insert the cassette as shown in thefigure, and then close the Cassette Compartment cover.2. Set the Function Selector to “TAPE/[qff]m.3. Press the Playback Button to begin tape playback.4. Adjust the Volume and Graphic Equalizer Controls tothe desired settings.5. To stop playback, press the Stop/Eject Button.Otherwise, at the end of the tape, the Playback Buttonwill be refeased and the unit will be shut off automatically.■ Full Auto-StopDuring playback, recording, fast forward or rewind when thetape reaches its end, the automatic stop system will releasethe operation buttons and automatically turn the unit off.Note that the unit is not turned off if the Function Selector isset to “RADIO” or TcdI/LINE”, it must be set to “TAPE/■ AntennasFM:Pull out the Telescopic Antenna and adjust its length andangle for optimum reception.AM:The sensitive ferrite core antenna inside the set will provideexcellent AM reception in most areas. For optimum recep¬tion, turn the set in the direction which gives the best results,since the ferrite core antenna is directional.■ Fast Forward and RewindThe tape will move rapidly forward when the Fast Forward/Cue Button is pressed.The tape will be rewound rapidly when the Rewind/ReviewButton is pressed.Note:Do not press the Playback Button during fast forwardor rewind, as this may jam the tape. Always press theStop/Eject Button first, between functions.■ Cue and ReviewIf the Fast Forward/Cue Button (or Rewind/Review Button)is pressed during playback, the recorded sound on the tapecan be monitored at a fast speed.When the button is released, playback will resume.■ Pause ButtonThe Pause Button can be used to temporarily stop the tapefrom moving during recording or playback.Before beginning a recording, first press and lock the PauseButton. Then, press the Record Button. (The tape will notmove.) When ready to record, press the Pause Button torelease it. This will start tape movement for immediaterecording._Note:Do not use the Pause Button to stop the tape for along period of time.The unit is not turned off when the Pause Button ispressed. Always use the Stop/Eject Button to turn theunit off.