6ADJUSTING AIRFLOW DIRECTIONADJUSTING AIRFLOW DIRECTION FOR MULTIPLEINDOOR UNITS USING SINGLE REMOTE CONTROLLER(WIRED) 4-Way Cassette 36" x 36" (Type U2)This air conditioners are equipped with auto flaps.You can set the airflow direction to a specific angle or to the sweep mode using the remotecontroller.Do not move the flap with your hands.• The air outlet flap can be easily removed and washed with water.• Be sure to always stop operation before removing the flap.• After washing with water, allow it to dry, and then remount it with the arrow facing outward. Ceiling (Type T2)A. Vertical directions (automatic)This air conditioner is equipped with an auto flap. You can set the airflow direction to a specificangle or to the sweep mode using the remote controller. (Refer to the description of the remotecontroller.)Do not move the flap with your hands.B. Horizontal directions (manual)The horizontal airflow direction can be adjusted manually by moving the vertical vanes to theleft or right.• If multiple indoor units are connected to a remote controller, the airflow direction can be set foreach indoor unit by selecting the indoor units (see the operation below).• To set the airflow for individual units, press the UNIT button. Display shows the indoor unitnumber under group control. Set the airflow direction for the indoor unit that is shown on thedisplay.• Each time UNIT is pressed, the indicator changes in the order shown below.• When nothing is displayed, you can make the setting for all indoor units in one operation.• The unit number is displayed as Outdoor Unit Number–Indoor Unit Number. It variesdepending on the number of units under group control.One outdoor unit and eight indoor units Two outdoor units and four indoor unitsNo display Unit No.1–1Unit No.1–2Unit No.1–3Unit No.1–8NodisplayUnitNo.1–1UnitNo.1–2UnitNo.1–3UnitNo.2–4UnitNo.1–4UnitNo.2–1