Panasonic S-22MM1E5A Installation Instructions Manual

Panasonic S-22MM1E5A Installation Instructions Manual Manual pdf 18 page image

185-4. Taping the Tubes(1) At this time, the refrigerant tubes (and electrical wiringif local codes permit) should be taped together witharmoring tape in 1 bundle. To prevent condensation fromoverflowing the drain pan, keep the drain hose separatefrom the refrigerant tubing.(2) Wrap the armoring tape from the bottom of the outdoorunit to the top of the tubing where it enters the wall. As youwrap the tubing, overlap half of each previous tape turn.(3) Clamp the tubing bundle to the wall, using 1 clamp approx.each meter. (Fig. 5-9)NOTEDo not wind the armoring tape too tightly since this willdecrease the heat insulation effect. Also ensure that thecondensation drain hose splits away from the bundle and dripsclear of the unit and the tubing.5-5. Finishing the InstallationAfter finishing insulating and taping over the tubing, use sealingputty to seal off the hole in the wall to prevent rain and draft fromentering. (Fig. 5-10)Insulated tubesDrain hoseClampApply putty hereTubingFig. 5-9Fig. 5-106. HOW TO INSTALL THE TIMER REMOTE CONTROLLER OR HIGH-SPEC WIREDREMOTE CONTROLLER (OPTIONAL PART)NOTERefer to the Operating Instructions attached to the optional Timer Remote Controller or optional High-spec Wired Remote Controller.7. HOW TO INSTALL WIRELESS REMOTE CONTROLLER RECEIVERNOTERefer to the Operating Instructions attached to the optional Wireless Remote Controller Receiver.AMP Air Conditioningwww.ampair.co.uk | sales@ampair.co.uk