Panasonic S-36PU1E5 Operating Instructions Manual

Also see for S-100PF1E5: Operating instructions Operating instructions Technical data & service manual Technical data & service manual Operating instructions

Contents

Panasonic S-36PU1E5 Operating Instructions Manual Manual pdf 8 page image

8ADJUSTING AIRFLOW DIRECTIONThe functions differ depending on the indoor unit used. The airflow direction cannot be setusing the remote controller for any unit which is not listed below.U1 type.• Never use your hands to move the flap (vertical airflow flap) that is controlled using theremote controller.• When the air conditioner is turned off, the flap (vertical airflow flap) automatically moves tothe downward position.• The flap (vertical airflow flap) moves to the upward position when performing the standbyoperation for heating. The swing operation is made after the standby operation for heating isreleased, but swing is indicated on the remote controller even during the standby operationfor heating.Setting the airflowdirectionThe airflow direction changes each time the FLAP button is pressed during operation.To activate the swingoperationPress the FLAP button to set the flap (vertical airflow flap) to the downward position, and thenpress the FLAP button again. This displays , and the airflow automatically swings up anddown.To stop the swingoperationPress the FLAP button again during the flap swing operation to stop the flap at the desiredposition. Then, the airflow can be set from the top position by pressing the FLAP button again.Indicator when swing operation is stoppedDuring cooling or drying operation, the flap will not stop at the downward position. Even if theflap is stopped at the downward position during the swing operation, it will not stop until itmoves to the third position from the top.Heating Cooling and drying Fan operation All operationsSet the flap (vertical airflow flap) to the downwardposition. If the flap is set to the upward position,the warm air may not reach the floor.The flap (vertical airflow flap) canbe set to one of three positions.Initial setting Initial settingInitial settingContinuousoperationFan and heating Cooling and drying