Panasonic S-36PU1E5 Technical Data & Service Manual

Also see for S-100PF1E5: Operating instructions Operating instructions Technical data & service manual Technical data & service manual Operating instructions

Contents

Panasonic S-36PU1E5 Technical Data & Service Manual Manual pdf 422 page image

8-1488-16. Common to All Models How to Install the Wireless Remote Controller Receiver1. Warnings about Installation of ReceiversThe wireless remote uses a very weak infrared light for its signal, which can result in the signal not being received because of thefollowing influences, so take care in where the unit is installed.• Inverter or rapid-start type fluorescent lights. (Models without glow lamps)• Plasma display or LCD televisions.• Direct sunlight or other sources of bright light.2. Warnings about Installing Remote Controls3. Things to remember when wired and wireless remotes are installed at the same timeIf a remote control is to be operated from a remote control holder that is hung on a wall, turn on the lights in the room as wellas any electrical appliances and then check to make sure the air conditioner works with the remote control in the locationwhere it will be installed. If it works, continue with installation.(1)If the air conditioner is to be switched from the main sensor to a remote control sensor, pay attention to the following wheninstalling.• Locate where no warm or cold drafts will affect it.• Locate in a place free from direct sunlight.• Locate where it will not be affected by any other heat/cold source.(2)Two remote controls can be used to control the unit if the wireless remote control kit is installed at the same time as the wiredremote control.(Up to 2 remotes [a wireless remote kit and the wired remote control] can be installed.)When using 2 remotes, one or more units can be operated by the remotes.When wiring remote controls, be sure to double-check the terminal numbers of the indoor unit before connecting them sothere are no mistakes in the wiring. (Damage will occur if high voltage [e.g. supply voltage] is applied)1.It is not possible to use more than one wireless remote control kit with one indoor unit.(A receiver located separately can be used at the same time)2.If both a wireless and a wired remote control are to be installed and used at the same time, one of them must be set up asthe sub remote control.3.If the wired remote control is to be the sub remote, change the wired remote control to the sub remote.If the wireless remote control is to be the secondary, turn the #3 switch on the wireless receiver (operation panel)from OFF to ON.If a group of units are to be controlled by 2 remote controls;Main/sub remote controls will work regardless of which indoorunit they are installed to.Wireless RemoteControl KitWired RemoteControl1st IndoorUnit2nd IndoorUnit3rd IndoorUnit4th IndoorUnit(Main) (Sub )Groundingwire (Earth)Cross-wiring Remotes for GroupControl (Field Supply)Use wiring of 0.5 mm 2 to 2 mm 2 for field supply.Make the total wire length when cross-wiring a group nomore than 200 m.When 1 indoor unit is operated by 2 remote controls:Either of the remotes can be set to main/sub.Wireless Remote Control Kit Wired Remote ControlReceiver(Sold Separately) (Sold Separately)Remote Control Wiring(Field Supply)Indoor UnitGroundingwire EarthUse wiring of 0.5 mm 2 to 2 mm 2 for field supply.Use a total wire length of no more than 400 m.(Main) (Sub)CN11 2 1 21 2 1 2CN1NOTE