Panasonic S-45PU1E5 Technical Data & Service Manual

Also see for S-100PF1E5: Operating instructions Operating instructions Technical data & service manual Operating instructions Operating instructions

Contents

Panasonic S-45PU1E5 Technical Data & Service Manual Manual pdf 369 page image

8-98Point the transmitter of the remote control at the receiver. When the signal is received correctly it will beep once.(It beeps twice only when the unit starts operating.)The signal can be received at a distance of about 6 meters. This distance should be used only as a guide.It depends on battery strength.Make sure nothing is between the remote control and the receiver that could block the signal.Do not leave the remote in direct sunlight, where the wind from the air conditioner can blow directly on it, or near any otherheat source.Take care not to drop, throw or wash the remote control with water.The signal from the remote control may not be received in rooms with rapid start fluorescent lighting, inverter lights, plasmadisplays, LCD televisions (monitor), etc. For more information, please contact the dealer where the product was purchased.12Fasten the remote controlmount with screws.Fitting the remotecontrol in the mount.Remote control mountPressPut inChecking AddressesWhen you press on the remote control, its current address is shown in the display. If this address corresponds to theaddress of a receiver * 2 , the buzzer sounds. (If it is on ALL, the buzzer will always sound.)If it is on ALL, it can be operated regardless of receiver addresses. Point the remote control at the receiver you wish to operateand transmit.*2 CZ-RWSL2 is a receiver. (Indoor unit)8-10. Using the Remote ControlWall Mount Use• Press from the location you wish to mount the remoteand make sure the signal is received correctly.• Pull the remote control forward to remove it.Don’t get the remote control too far away from the receiver.This may cause a malfunction. Be sure to keep the remote control in the same room as the receiver.remote control, addresses can be set up to avoid crosstalk. By setting the address switches on the receivers and matchingthem with the number of addresses on the remote control, up to six indoor units can be controlled separately with the remotecontrol. (When using units in a flexible combination or operating multiple units simultaneously, as they are operated at thesame time, they cannot be controlled individually.) There are separate address settings, receiver addresses for the receivers*and transmitter addresses for the remote control.For more information, please contact the dealer where the product was purchased.1• The setting procedure is different for Indoor Unit (K1 type). (See Setting Addresses (K1 Type) in the next page.)• These settings are saved in nonvolatile memory in the remote control, so even when its batteries are changed, the settingsdo not have to be made again.* 1 CZ-RWST2 is of a receiver (Inside the indoor unit); CZ-RWSL2 is of an operation panel. (Inside the indoor unit)8-11. For Best ResultsPoint the remote control at the receiver.When the signal is received correctly it will beep one time.Avoid locating the remote control where it is covered, such as behind a curtain.Keep it out in the open.In both multi and single unit installations, when more than one indoor unit is installed in the same room with a compatible8-12. Addresses