8RQT6193SettingsChange the settings to suit your speakers and units to the environment in which you are using them. Before making any changes, read thedescriptions of the settings, note the factory settings and ranges, and refer to the equipment’s instructions.SFC MODEw qPress at the sametime to enter thesetting mode.SIZESet the size to suityour speakersDISTANCEEnter the distance ofthe front, center andsurround speakersfrom the seatingpositionFILTERChange the cut-offfor bass output fromthe front speakersLARGE:For speakers that can reproduce a full sound range, particularlythe bass range below 100 Hz.SMALL: For speakers that cannot adequately reproduce the bass range.This setting is sufficient for most speakers if you are using asubwoofer.NONE: For speakers you haven’t connected (center or surround).The factory settings are: FRONT: LARGECENTER and SURROUND: SMALLFor the subwoofer (SUB-WFR), select YES if you have connected one(factory setting), or NO if you have not.If you set the front speakers to “SMALL”, the filter is set to 100 Hz. Raisethe cut-off if the bass from the front speakers is unsatisfactory so that thisbass is output through the subwoofer.You can raise the cut-off from 100 Hz to either 150 Hz or 200 Hz.Change the distance so that the sound from all the speakers (except forthe subwoofer) reaches you at the same time.You can select distances between 3 and 30 feet at one-foot intervals.The factory settings are: FRONT and CENTER: 10 FEETSURROUND: 5 FEETAdjustingspeaker outputlevelSPEAKERSTurn SPEAKERSon.Adjust the level of the other speakers based on the output of the frontspeakers. (Adjust the volume of the front speakers with [VOLUME].)C (center), SR (surround right), and SL (surround left) can be adjustedbetween –10 dB and +10 dB, with 0 being the level of the front speakers.Adjust center and surround output to the same apparent level of the frontspeakers.For SW (subwoofer), you can select “---” so there is no output, “MIN” forminimum output, a level between 1 and 19, or “MAX” for maximum output.Adjust subwoofer output so it is balanced with the front speakers.Subwoofer output is easily influenced by the source. You can also changeits level while playing something for better effect (\ page 13).1235D-INPUTDigital inputChange these settings to suit the connections you have made to the threedigital input terminals, COAX, OPT1 and OPT2, so that the correct sourceis selected when you turn [INPUT SELECTOR].The factory settings are: CD: COAXDVD:OPT 2TV: OPT 14Step 1 2 3 4