Panasonic SA-MAX9000GN Service Manual

Also see for SA-MAX9000GN: Service manual

Contents

7Figure 2-12.3. General description about Lead Free Solder (PbF)The lead free solder has been used in the mounting process of all electrical components on the printed circuit boards used for thisequipment in considering the globally environmental conservation.The normal solder is the alloy of tin (Sn) and lead (Pb). On the other hand, the lead free solder is the alloy mainly consists of tin(Sn), silver (Ag) and Copper (Cu), and the melting point of the lead free solder is higher approx.30 degrees C (86°F) more than thatof the normal solder.Definition of PCB Lead Free Solder being usedService caution for repair work using Lead Free Solder (PbF)• The lead free solder has to be used when repairing the equipment for which the lead free solder is used.(Definition: The letter of “PbF” is printed on the PCB using the lead free solder.)• To put lead free solder, it should be well molten and mixed with the original lead free solder.• Remove the remaining lead free solder on the PCB cleanly for soldering of the new IC.• Since the melting point of the lead free solder is higher than that of the normal lead solder, it takes the longer time to melt thelead free solder.• Use the soldering iron (more than 70W) equipped with the temperature control after setting the temperature at 350±30 degreesC (662±86°F).Recommended Lead Free Solder (Service Parts Route.)• The following 3 types of lead free solder are available through the service parts route.RFKZ03D01K-----------(0.3mm 100g Reel)RFKZ06D01K-----------(0.6mm 100g Reel)RFKZ10D01K-----------(1.0mm 100g Reel)Note* Ingredient: tin (Sn), 96.5%, silver (Ag) 3.0%, Copper (Cu) 0.5%, Cobalt (Co) / Germanium (Ge) 0.1 to 0.3%2.4. Handling Precautions for Traverse Ass’yThe laser diode in the optical pickup unit may break down due to static electricity of clothes or human body. Special care must betaken avoid caution to electrostatic breakdown when servicing and handling the laser diode in the traverse unit.2.4.1. Cautions to Be Taken in Handling the Optical Pickup Unit (OPU)The laser diode in the optical pickup unit may be damaged due to electrostatic discharge generating from clothes or human body.Special care must be taken avoid caution to electrostatic discharge damage when servicing the laser diode.1. Do not give a considerable shock to the optical pickup unit as it has an extremely high-precise structure.2. To prevent the laser diode from the electrostatic discharge damage, the flexible cable of the optical pickup unit removedshould be short-circuited with a short pin or a clip.3. The flexible cable may be cut off if an excessive force is applied to it. Use caution when handling the flexible cable.4. The antistatic FFC is connected to the new optical pickup unit. After replacing the optical pickup unit and connecting the flexi-The letter of “PbF” is printed either foil side or components side on the PCB using the lead free solder.(See right figure)