Panasonic SB-TP20 Operating Instructions Manual

Contents

RQT69012Safety precautionsPlacementSet the unit up on an even surface away from direct sunlight, hightemperatures, high humidity, and excessive vibration. These conditionscan damage the cabinet and other components, thereby shorteningthe unit’s service life.VoltageDo not use high voltage power sources. This can overload the unitand cause a fire.Do not use a DC power source. Check the source carefully whensetting the unit up on a ship or other place where DC is used.AC mains lead protectionEnsure the AC mains lead is connected correctly and not damaged.Poor connection and lead damage can cause fire or electric shock.Do not pull, bend, or place heavy items on the lead.Grasp the plug firmly when unplugging the lead. Pulling the ACmains lead can cause electric shock.Do not handle the plug with wet hands. This can cause electricshock.Foreign matterDo not let metal objects fall inside the unit. This can cause electricshock or malfunction.Do not let liquids get into the unit. This can cause electric shock ormalfunction. If this occurs, immediately disconnect the unit from thepower supply and contact your dealer.Do not spray insecticides onto or into the unit. They containflammable gases which can ignite if sprayed into the unit.ServiceDo not attempt to repair this unit by yourself. If sound is interrupted,indicators fail to light, smoke appears, or any other problem that is notcovered in these operating instructions occurs, disconnect the ACmains lead and contact your dealer or an authorized service center.Electric shock or damage to the unit can occur if the unit is repaired,disassembled or reconstructed by unqualified persons.Extend operating life by disconnecting the unit from the powersource if it is not to be used for a long time.Insertion of connectorEven when the connector is per-fectly inserted, depending on thetype of inlet used, the front part ofthe connector may jut out as shownin the drawing.However there is no problem usingthe unit.ConnectorApprox. 6 mmAppliance inletCaution for AC mains lead(For the United Kingdom)(“EB” area code model only)For your safety, please read the following text carefully.This appliance is supplied with a moulded three pin mains plug foryour safety and convenience.A 5-ampere fuse is fitted in this plug.Should the fuse need to be replaced please ensure that the re-placement fuse has a rating of 5-ampere and that it is approved byASTA or BSI to BS1362.Check for the ASTA mark m or the BSI mark o on the body of the fuse.If the plug contains a removable fuse cover you must ensure that itis refitted when the fuse is replaced.If you lose the fuse cover the plug must not be used until a replace-ment cover is obtained.A replacement fuse cover can be purchased from your local dealer.If a new plug is to be fitted please observe the wiring code as statedbelow.If in any doubt please consult a qualified electrician.IMPORTANTThe wires in this mains lead are coloured in accordance with thefollowing code:Blue: Neutral, Brown: Live.As these colours may not correspond with the coloured markingsidentifying the terminals in your plug, proceed as follows:The wire which is coloured Blue must be connected to the terminalwhich is marked with the letter N or coloured Black or Blue.The wire which is coloured Brown must be connected to the terminalwhich is marked with the letter L or coloured Brown or Red.WARNING: DO NOT CONNECT EITHER WIRE TO THEEARTH TERMINAL WHICH IS MARKED WITH THE LET-TER E, BY THE EARTH SYMBOL nnnnn OR COLOUREDGREEN OR GREEN/YELLOW.THIS PLUG IS NOT WATERPROOF—KEEP DRY.Before useRemove the connector cover.How to replace the fuseThe location of the fuse differ according to the type of AC mainsplug (figures A and B). Confirm the AC mains plug fitted and followthe instructions below.Illustrations may differ from actual AC mains plug.1. Open the fuse cover with a screwdriver.2. Replace the fuse and close or attach the fuse cover.Fuse coverFigure A Figure BFuse(5 ampere)Fuse(5 ampere)Figure A Figure BCAUTION!IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THESOCKET OUTLET IN YOUR HOME THEN THE FUSESHOULD BE REMOVED AND THE PLUG CUT OFF ANDDISPOSED OF SAFELY.THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IFTHE CUT OFF PLUG IS INSERTED INTO ANY 13-AMPERESOCKET.