Panasonic SC-AK450 Operating Instructions Manual

Also see for SB-AK450: Operating instructions Service manual Service manual Service manual Service manual

5RQT8043RQTV0191LANG - 5 LANG - 4 FRANÇAIS DANSK ENGLISHAdhesivetapeOptional antenna connectionsOptional antenna connectionsUse outdoor antenna if radio reception is poor.Note:Disconnect the outdoor antenna when the unit is not in use. Do not use the outdoor antenna during a lightning storm.FM outdoor antenna AM outdoor antenna( )Rear panelof this unitFM outdoor antenna(not included)75 Ω coaxial cable(not included)Rear panelof this unitAM outdoor antenna(not included)AM loop antenna(included)5-12 m(16 - 40 ft.)• Disconnect the FM indoor antenna.• The antenna should be installed by a competenttechnician.• Run a piece of vinyl wire horizontally across a window orother convenient location.• Leave the loop antenna connected.Preparing the remote controlPreparing the remote controlAA/R6/LR6■ Batteries• Insert so the poles (+ and –) match those in the remote control.• Remove if the remote control is not going to be used for a long period oftime. Store in a cool, dark place.• Replace if the unit does not respond to the remote control even when heldclose to the front panel.• Do not use rechargeable type batteries.• Mishandling of batteries in the remote control can cause electrolyteleakage, which may cause a fire.• If electrolyte leaks from the batteries, consult your dealer.Wash thoroughly with water if electrolyte comes in contact with any part ofyour body.Do not:• mix old and new batteries.• use different types of batteries at the same time.• heat or expose batteries to flame.• take apart or short circuit the batteries.• attempt to recharge alkaline or manganese batteries.• use batteries if the covering has been peeled off.• put heavy objects on the remote control.• spill liquids onto the remote control.■ UseAim at the remote control sensor, avoiding obstacles, at a maximum rangeof 7 m (23 feet) directly in front of the unit.Refer to page 6 for the remote control sensor position.DEMO functionDEMO function7, STOP, –DEMO- +When the unit is first plugged in, a demonstration of its functions may beshown on the display.If the demo setting is off, you can show a demonstration by selecting “DEMOON”.Press and hold [7, STOP, –DEMO].The display changes each time the button is held down.NO DEMO (off) Ô DEMO ON (on)While in standby mode, select “NO DEMO” to reduce power consumption.Note:DEMO function cannot be turned on when DIMMER is on.