Panasonic SC-AK78 Operating Instructions Manual

Also see for SB-PC70: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

RQT528914Presetting radio broadcasts• Up to 12 stations can be set in each band with automatic or manualmemory presetting.• If broadcast frequencies are preset in the memory, you can easilytune in any of these frequencies from the system or remote controlunit.• You can preset just those stations you like. (See “Presetting onlyyour favorite stations” below.)1. Press [TUNER/BAND] to select band.The power will come on automatically.Every time you press the button; “FM” “AM”.2. Press [ , TUNE MODE] to select “MANUAL”.Every time you press the button; “MANUAL” “PRESET”.3. Press [TUNE / TIME ADJ( or )] until the dis-play shows the frequency from which you wantto begin automatic memory presetting.Tips on tuning in radio stationsHold down either [TUNE/TIME ADJ ( or )] until the fre-quency numbers start scrolling.When near to the frequency you are looking for, press [TUNE/TIME ADJ ( or )] repeatedly until the station is tuned in.4. Press and hold [ , MEMORY] until the fre-quency begins to change.This will start presetting automatically. When finished, the radiowill tune in the last station memorized.If auto presetting is not possible because radio signals are weakor for some other reason, do the following.Presetting only your favorite stationsPreset the stations one at a time.1. Perform step 1 above. Then, press [ , MEMORY] (“PRGM”flashes) and select a station with [TUNE/TIME ADJ ( or )].2. While “PRGM” is flashing press [ , MEMORY] again and se-lect a preset channel with [TUNE/TIME ADJ ( or )].3. Press [ , MEMORY] to preset the station.Memory retentionThe preset stations are retained in memory for about 2 weeks even ifthe system is unplugged.FM allocation settings:This system comes equipped with an electronic digital tuner that di-vides the broadcast band into many small steps. These steps matchthe assignable broadcast frequencies and intervals in between.Each country allocates broadcast bands according to their particularneeds.By adjusting the allocation, you can enable the tuner to receive FMbroadcasts allocated in 0.1 MHz steps.Press and hold [TUNER/BAND]. After a few seconds the display willchange to a flashing display of the current minimum frequency. If youcontinue to hold [TUNER/BAND] down, the minimum frequency willchange. Release the button at this time.To return to the original frequency indication, repeat above.NoteAfter changing the allocation setting, the frequencies you previouslypreset in the memory will be cleared.12341243Preset channelPreparations