Panasonic SC-MAX700 Operating Instructions Manual

Contents

17 RQT983817“PLAYERROR”• You played an unsupported MP3 file. The system willskip that track and play the next one.“REMOTE 1”“REMOTE 2”• The remote control and the main unit are using differentcodes. Change the code of the remote control.– When “REMOTE 1” is shown, press and hold [OK]and [1] for a minimum of 4 seconds.– When “REMOTE 2” is shown, press and hold [OK]and [2] for a minimum of 4 seconds.“TEMP NG”• The temperature protection circuit has been activated,and the system will switch off. Let the unit cool downbefore switching it on again.• Check that the ventilation opening of the unit is notobstructed.• Ensure this unit is well ventilated.“USB OVER CURRENT ERROR”• The USB device is using too much power. Disconnectthe USB device, switch off the system and then switchon again.“USE USB B”• You cannot record tracks from a USB device in USB Ato the internal memory. Connect the USB device toUSB B and try again.“VBR–”• The system cannot show the remaining play time forvariable bit rate (VBR) tracks.System memory reset (initialisation)Reset the memory when the following situations occur:• There is no response when buttons are pressed.• You want to clear and reset the memory contents.1 Disconnect the AC mains lead.2 While you press and hold [1] on the main unit,connect the AC mains lead again.Continue to press and hold the button(approximately 10 seconds) until “– – – – – – – –” isshown.3 Release [1].All the settings are set back to the factory preset.It is necessary to set the memory items again.Remote control codeWhen other Panasonic equipment responds to theremote control of this system, change the remote controlcode for this system.PreparationPress [RADIO/EXT-IN] to select “MUSIC PORT” or “AUX”.To set the code to “REMOTE 2”1 Press and hold [RADIO/EXT-IN] on the main unitand [2] on the remote control until “REMOTE 2”is shown.2 Press and hold [OK] and [2] for a minimum of 4seconds.To set the code to “REMOTE 1”1 Press and hold [RADIO/EXT-IN] on the main unitand [1] on the remote control until “REMOTE 1”is shown.2 Press and hold [OK] and [1] for a minimum of 4seconds.MaintenanceTo clean this system, wipe with a soft, dry cloth.• Never use alcohol, paint thinner or benzine to cleanthis system.• Before using chemically treated cloth, read theinstructions that came with the cloth carefully.ENGLISH