97LSQT1426This section explains the main messages appearing on the LCD monitor andhow to deal with them.Message What to checkPLEASE CONNECT ACADAPTORYou tried connecting the unit to a computer withoutconnecting the AC adaptor.ERROR OCCURRED.PLEASE TURN UNITOFF, THEN TURN ONAGAIN.The unit detected an error. Eject the SD card and shutpower off and turn back on.DISCONNECT USBCABLE.The unit is not properly connected to a computer orprinter.Disconnect and reconnect the USB cable.CANNOT OPERATEWHILE CONNECTEDTO COMPUTER.Power to the unit cannot be shut off while it isconnected to a computer.Disconnect USB cable.CARD ERROR HASOCCURRED.TO REPAIR THE CARD, PLEASECONNECT AC ADAPTOR ORCHANGE BATTERY.The data on the SD card contains errors.To repair the data, either use a battery of sufficient lifeor connect the AC adaptor. Depending on the error, itmay take time to repair the data.NOW REPAIRINGDATA.DO NOT REMOVECARD.The data has been repaired.Depending on the situation, the data may not becompletely repaired.If power is shut off without repairing data, data canbe repaired the next time that power is turned on.If repairing fails, the data cannot be played back.Format the SD card with this unit.Do not repair SD cards recorded on other deviceson this unit.●●●●CANNOT CHECKCONNECTED DEVICE.DISCONNECT THEUSB CABLE FROMTHIS UNIT.A device that cannot be used with this unit isconnected to the unit.ENVIRONMENT TOODARK, OR LENSCOVER CLOSED.Before recording, open the lens cover.This message may appear if you try to record in anextremely dark placeAfter the power is turned on, the message isdisplayed when the initial recording mode isestablished, but it is not displayed when manualrecording is performed.●●●