Panasonic SL-CT490 Operating Instructions Manual

Contents

Button Display/referenceOperationTo pause playTo stop playTo turn off theunitSkip forward/backward(skip function)Rapid forward/backward(search function)Off modeStop mode21 45HOLD3HOLDËOPENVOLMEMORYRECALLEQMODEOPENS-XBSVOLCVOLS-XBSCLRVOLFor your reference:“)” indicationThis indication appears for about 30 seconds if [1/;] ispressed when no disc is loaded in the unit or if the discis not properly secured.“*” indicationThis indication appears for about 10 minutes when thecover is opened. (However, the indication does not ap-pear when the unit is powered off.)Removing discs1 Press [∫] to stop play and disc rotation.2 Slide [OPEN 1] to open the lid.3 Once the disc has stopped, lift the discout with your finger.Do not stop the disc by hand or try to remove it before itstops rotating. This can damage CDs.Note!Never insert foreign objects into the unit.Auto-off functionIf you leave the unit in stop mode for about 10 minites(30 seconds if disc is not loaded), it turns off to save thebatteries.3Sequential Play Basic PlayElapsed playing time of each trackTrack number in playClose the lidPlug type:3.5 mm (1/8 in.) stereoDecrease Increase≥During program play (page 4), these buttons areused to skip forward or backward through theprogrammed sequence of tracks.≥You cannot skip to tracks that have been playedin random or random repeat play (page 4).≥During program play, 1-track repeat play, randomplay and random repeat play (page 4), search op-eration is limited to the current track only.Press during play.Press during play.Press during stop mode.Press during play.(Press [:] twice to skip to thebeginning of the previous tracks.)Press again to restart play.Press and hold during play.Backward ForwardCCCTotal number of tracksTotal playing timeResume function notes≥Opening the lid while in the stop mode or replacing the disc while in the off mode cancels the function. (It may re-main active if you replace a disc in the off mode.)≥Play may resume from the beginning of the next track if you stopped play near the end of a track.≥The resume function works automatically and cannot be turned off.No indicator is shown.Resume functionPlay starts from the beginning ofthe current track the next time youpress [1/;].Note on CD-R and CD-RWThis unit can play CD-DA format audio CD-R andCD-RW that have been finalized§ upon completionof recording. It may not be able to play some CD-Ror CD-RW due to the condition of the recording.§Finalizing is a process that enables CD-R/CD-RWplayers to play audio CD-R and CD-RW.Follow steps 1–5.In step 2: Connect the clip headphones/ stereo earphones and wired remote control to the headphone jack [Ë] .(Plug in firmly.)In step 5: The volume range is 0-25. Press and hold to change the volume successively. The volume changes whenpressed while the level is displayed. If any other display is shown, it changes to show the current level.(The volume returns to 10 when you disconnect the power source.)≥Play stops automatically when all the tracks have been played.≥If the unit has been connected to the car audio system, set this unit’s volume to 10, then adjust the volume level onthe system.Label must faceupward. Pressnear the centerso the disc clicksfirmly into place.