576-10-770 DBS 576 - Issued 3/23/98 5IntroductionThe incorporation of a voice recognition unit (VB-44101) in a soft-keytelephone (VB-44224) allows you to choose between voice-activated dialingor normal keying in. You can simply speak names stored in the Phonebook toinitiate a call to that destination.This manual describes how to use voice-activated dialing and how to recordnames, etc. See the Operation Instruction (Section 700) for details of normalkey operations.This manual consists of the following chapters:• We recommend storing your spoken commands in your own voice inthe system to improve the performance of voice recognition.Chapter Content Reference page1. Making outside call(or Internal call) Describes how to make calls to exchange (or in-ternal) numbers by speaking names recorded inthe Phonebook 82. Adding a PhonebookEntry Describes how to record names and phone num-bers in the Phonebook 103. Modifying a Phone-book Entry Describes how to change names and phone num-bers recorded in the Phonebook 144. Deleting a PhonebookEntry Describes how to delete names and phone num-bers from the Phonebook 215. Tuning the commandsto Your Voice Describes how you, as user, store your spokencommands in the system for use as a reference. 266. Resetting The System Describes how to reset the system to its statewhen shipped (The original non-specific "user"voice is restored and the contents of the Phone-book deleted.)30CAUTION:• If the system cannot recognize your spoken commands, operate bykeys. There is no key equipped on the telephone corresponding to"Repeat" command.• Your spoken command can be recognized only during Large LED(Message LED) lights Red.• When a spoken command is not recognized, an error tone is gener-ated. At this point, make sure your spoken command is valid andtry again.• Once entering the voice recognition made, to turn to the OFF-HOOK Monitor mode is not available. To use OFF-HOOK Moni-tor mode, lift the handset and press ON/OFF Key, then pressSTART Key.