|
225 Adjustment5.1. VCO Adjustments1) Turn the +B/ACC on2) Move to [Diagnosis for Manufacturer] screen. (Refer to theworking instructions)3) Touch the [Color Bar Check] on the screen4) Touch the [VCO Adj] on the screen5) Check if the color bar of the VTR input is appeared.Press the [TUNE/TRCK UP/DOWN] key or [VOL UP/DOWN]key and adjust so that thecolor bar is displayed properly.*The adjustment value is displayed on the screen*The adjustment point is set at the center of the 3 points of theadjustment values thatdisplays the color6) Touch the screen7) Return to [Color Bar Check] screen*Always return by touching the screen*If mis-operated, go back to 2) and readjust.8) Touch the [VCO Adj] and check the adjustment value.9) Touch the screen10) Turn the +B/ACC off5.2. Flicker Adjustments1) Turn the +B/ACC on2) Set to [Diagnosis for Manufacturer] screen3) Touch the [Color Bar Check] on the screen4) Select the [TFT adj] on the screen5) Press the [TUNE/TRCK UP/DOWN] key or [VOL UP/DOWN]key and adjust so thatthe screen flickering will be at minimum.*The viewing angle goes by the below diagram*The adjustment value is displayed on the screen6) Touch the screen Å® goes back to the color bar inspectionscreen* Always return by touching the screen* If mis-operated, go back to 2) and readjust.7) Touch the [TFT Adj] and check the adjustment value.8) Touch the screen and return to [Color Bar Check] screen.9) Turn the +B/ACC off5.3. Calibration Adjustments1) Turn the +B/ACC on2) Move to [Diagnosis for Manufacturer] screen. (Refer to theworking instructions)3) Touch the [Calibration Check] on the screen.4) Press [VOL DOWN] or [TRCK UP] while pressing the "+" dis-played on the screen.Do the above operations as shown on the right diagram from[1] to [5] in order andfinally press the OK key at [6]
|
