2.1 LED display changeDisplay style set by the LED display change button13You can display the following items using the LED display switch button.Display for the connection with a connected terminal (Status mode),Display forthe 1000 Mbps transmission rate (GIGA mode),Display for the 100Mbps or 10Mbps transmission rate (Speed mode),Display for the full-duplex or half-duplextransmission system (DUPLEX mode),Display for ports with a loop history (Loophistory mode),All port LED lamps can be turned OFF (ECO mode).Two types of Base modes and each modeThe mode at the start is called “Base mode.”There are two types of Base modes:Status mode (factory default setting) and ECOmode.You can change the Base mode by holding down the LED display switchbutton (for at least 3 sec).When the Base mode is changed normally,all STATUS/ECO,GIGA,100M,and FULLLED lamps light up at the same time.When you release the button,the Base mode ischanged to the selected mode.If the mode is changed to the GIGA mode,Speed mode,DUPLEX mode,or loophistory mode and the LED display switch button is not used for one minute orlonger,the mode automatically returns to a Base mode (Status mode or ECO mode).The Base mode is maintained even after the power is turned OFF.SFPSFP232421191715131192220181614121075318642RIGHT LED(ORANGE):LOOP DETECTIONCONSOLE9600.N.8.1(DTE)ANY COL.POWERSTATUS/ECOGIGA100MFULLLOOP HISTORYSwitch-M24eGLED DISPLAYCHANGE BUTTONKEEP PRESSING 3SECECO MODE ON/OFFIndication on the front panel andLED lampsLED display switch button